Grizzly w1702 Introduction, About Your New Shaper, Woodstock Service and Support

Page 4

INTRODUCTION

INTRODUCTION

About Your New Shaper

Your new SHOP FOX® Model W1702 3 HP Shaper is specially designed to provide many years of trouble- free service. Close attention to engineering detail, ruggedly built parts, and a rigid quality control program assure safe and reliable operation.

The Model W1702 features a 3 HP, 220V single-phase motor with forward/reverse spindle control. Also included are a heavy-duty miter gauge, fence with safety guard, cast iron handwheel, large precision ground cast iron table, and all ball bearing construction. The shaper comes with a 1⁄2" and 3⁄4" spindle, and operates at either 7,000 or 10,000 RPM depending on the pulley ratio.

For further features and details, refer to the Specifications section on Page 3.

Woodstock International, Inc. is committed to customer satisfaction in providing this manual. It is our intent to include all the information necessary for safety, ease of assembly, practical use and durability of this product.

If you need the latest edition of this manual, you can download it from http://www.shopfox.biz.

If you still have questions after reading the latest manual, or if you have comments please contact us at:

Woodstock International, Inc.

Attn: Technical Support Department

P.O. Box 2309

Bellingham, WA 98227

Woodstock Service and Support

We stand behind our machines! In the event that a defect is found, parts are missing or questions arise about your machine, please contact Woodstock International Service and Support at 1-360-734-3482 or send e-mail to: tech-support@shopfox.biz. Our knowledgeable staff will help you troubleshoot problems, order parts or arrange warranty returns.

-2-

Page 3 Page 5
Image 4
Page 3 Page 5
Contents HP Shaper Page Contents Introduction Woodstock Service and SupportAbout Your New Shaper Warranty and Returns SpecificationsSafety Standard Safety InstructionsSafety Additional Safety Instructions for Shapers Avoiding Potential Injuries Use a Shop FOX Featherboard asElectrical 220V OperationExtension Cords GroundingUnpacking AssemblyInventory Initial Cleaning BeginningDust Collection Shop PreparationFence Facing Safety GuardAuxiliary Guard To install the hold-downs, do these steps To install the crank handle, do these stepsHold-Downs HandwheelSpindle Unplug the ShaperThreading drawbar nut onto drawbar To adjust the fence, do these steps AdjustmentsFence Positioning Fence Alignment To adjust the table inserts, do these steps Table InsertsPulley Alignment To align the pulleys, do these stepsChoose Spindle RPM Spindle RPMTo change the spindle RPM, do these steps Spindle Slide and Gib To check the spindle slide-to-gib clearance, do these stepsOperations Start UpForward and reverse switch Cutter DirectionCutter Installation Choose Cutter Profile and CutterChoose Cutter Height and Spindle Size Choose Spindle and Cutter RPMPlace the spindle washer onto the spindle as shown in Figure Setting Spindle Height To set the spindle height, do these stepsStraight Shaping Operations There are three set up positions for rub collars Rub CollarsFreehand Shaping Starting pin operation Guard not shown for clarityPattern Shaping To make a template, do these stepsMaintenance GeneralTable and Base LubricationTroubleshooting Closure Model W1702 220V Wiring Diagram Parts Stand Parts Handle Parts XPR15M Parts XPW02 Lock Washer 3⁄8 Parts Miter Gauge Body HOLD-DOWN BAR Shaper Accessories Shaper Accessories Your Notes Your Notes Warranty Card BOX BELLINGHAM, WA
Top Page Image Contents