Bosch Power Tools CCS180K, CCS180B manual Operating Instructions, Trigger, Foot Blade Screw

BM 2610034442 03-14_CCS180 3/27/14 12:25 PM Page 10

Operating Instructions

DEPTH ADjUSTMENT

Disconnect battery pack from tool. Loosen the depth adjustment lever located on the right side of the tool. Hold the foot down with one hand and raise or lower saw by the handle.

Tighten lever at the depth setting desired. Check desired depth (Fig. 3).

Not more than one tooth length of the blade should extend below the material to be cut, for minimum splintering (Fig. 4).

FIG. 3 FIG. 4

DEPTH

CALIBRATED DEPTH ADJUSTMENT

BRACKETLEVER

ONE TOOTH LENGTH SHOULD

PENETRATE WOOD FOR MINIMUM SPLINTERING

SAFETy SWITCH

The safety switch is designed to prevent accidental starts. To operate safety switch, press the release button with your thumb on either side of handle to disengage the lock, then pull the trigger (Fig. 5). When the trigger is released the button will engage the safety switch automatically, and the trigger will no longer operate. (See Switch & General Cuts on page 12.)

FIG. 5

SAFETY SWITCH

RELEASE BUTTON

90° CUTTING ANGLE CHECK

Disconnect battery pack from tool. Set foot to maximum depth of cut setting. Loosen bevel adjustment lever, set to 0° on quadrant, retighten lever and check for 90° angle between the blade and bottom plane of foot with a square (Fig. 6). Make adjustments by turning the small alignment screw from bottom side of foot, if necessary (Fig. 7).

FIG. 6	BEVEL	FIG. 7
	ADJUSTMENT
	KNOB

TRIGGER

		ALIGNMENT
FOOT	BLADE	SCREW

-10-