Porter-Cable 90550130 Battery CAP Information, Storage Recommendations, Charging Procedure

Page 7

90550130 PC1800HD hammer drill 4/3/09 2:40 PM Page 7

•Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persists, seek medical attention.

: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

•Charge the battery packs only in PORTER-CABLEchargers.

•DO NOT splash or immerse in water or other liquids. This may cause premature cell failure.

•Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in summer).

: Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling.

BATTERY CAP INFORMATION

Battery Cap

Battery storage and carrying caps are provided for use whenever the battery is out of the tool or charger. Remove cap before placing battery in charger or tool.

: Fire hazard. Do not store or carry battery so that metal objects can contact exposed battery terminals. For example, do not place battery in aprons, pockets, tool boxes, product kit boxes, drawers, etc., with loose nails, screws, keys, etc.

Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes (i.e., packed in suitcases and carry-on luggage) UNLESS they are properly protected from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit. NOTE: LI-ION batteries should not be put in checked baggage.

STORAGE RECOMMENDATIONS

1.The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold.

2.Long storage will not harm the battery pack or charger. Under proper conditions LI-ION batteries, can be stored for 5 years or more.

CHARGING PROCEDURE

PORTER-CABLEchargers are designed to charge PORTER-CABLEbattery packs in 30-60 minutes depending on the pack being charged.

1.Plug the charger into an appropriate outlet before inserting the battery pack.

2.Insert the battery pack into the charger. (Fig. B)

B

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Catalog Number Advertencia Léase EstePC1800HD Work area safety General Power Tool Safety WarningsSpecific Safety Rules Symbols Safety Guidelines DefinitionsNI-CD Battery Packs and Chargers Description Cat. # Important Safety Instructions for Battery ChargersWire Size AWG LI-ION Battery Packs and Chargers Description Cat. #Read ALL Instructions Important Safety Instruction for Battery PacksCharging Procedure Battery CAP InformationStorage Recommendations Leaving the battery in the charger Bad batteryHot/Cold pack delay Problem power lineSafety Warnings and Instructions Drills Installing and Removing the Battery Pack From the ToolDual Range Gearing Figure H Trigger Switch & Forward/Reverse Button Figure FAdjusting Torque Control Figure G Hammer ActionDrilling Keyless Chuck FigureScrew Driving On Board Bit StorageSpecialnotes for USE with Lithium Batteries TroubleshootingMaintenance Replacement Parts Service and RepairsAccessories Three Year Limited WarrantyDE Catalogue Manuel dinstructions90550130 PC1800HD hammer drill 4/3/09 240 PM 90550130 PC1800HD hammer drill 4/3/09 240 PM Consignes DE Sécurité Particulières Description De cat SymbolesLignes Directrices EN Matière DE Sécurité Définitions Calibre AWGDescription fonctionnelle Lire Toutes LES Directives Procédure DE Charge Recommandations EN Matière DE RangementInformation Concernant LE Capuchon DU BLOC-PILE Laisser de piles au LI-ION dans les bagages enregistrésProblème Avec LE Secteur Fonctions DE Diagnostic DU ChargeurPile EN Mauvais État Fonction DE Suspension DU BLOC-PILES CHAUD/FROIDInsertion ET Retrait DU BLOC-PILES DE L’OUTIL Avertissements de sécurité et directives perceusesLa figure E Percussion FonctionnementRéglage DU Couple Figure G Rangement Intégré DES Embouts Mode TournevisMode Perçage Mandrin AUTO-SERRANT FigureEntretien LE Sceau SrprcmcDépannage Remarques Spéciales SUR L’EMPLOIAVEC DES Pilesau LithiumEntretien ET Réparation AccessoiresRemplacement DES Étiquettes D’AVERTISSEMENT Garantie Limitée DE Trois ANSHighway 45 North Jackson, Tennessee 888 Manual deinstrucciones Taladro percutor inalámbrico de 13 mm 1/2 pulgadas y 18Catálogo N 90550130 PC1800HD hammer drill 4/3/09 240 PM 90550130 PC1800HD hammer drill 4/3/09 240 PM Normas DE Seguridad Específicas Descripción De cat Pautas DE SEGURIDAD/DEFINICIONESSímbolos Tamaño AWG del conductorFigura a Descripción DE LAS FuncionesLEA Todas LAS Instrucciones Recomendaciones CON Respecto AL Almacenamiento Información Acerca DEL Protector DE LA BateríaProcedimiento DE Carga Retraso POR Paquete CALIENTE/FRÍO Línea DE Potencia CON ProblemasDiagnóstico DEL Cargador Batería EN MAL EstadoInstrucciones Y Advertencias DE Seguridad Taladros En la figura CAjuste DEL Control DE Torsión Figura G Instrucciones DE OperaciónAcción de percusión Interruptor Disparador Y Botón DE AVANCE/REVERSA Figura FTaladrado Portabrocas SIN Llave FiguraDestornillado Espacio EN LA Herramienta Para Guardar PuntasEL Sello Rbrc Detección DE ProblemasTaladrado EN Mampostería Notas Especiales Paraeluso CON Baterías DE LitioPiezas DE Repuesto Mantenimiento Y Reparaciones Garantía Limitada DE Tres AñosAccesorios Reemplazo DE LAS Etiquetas DE Advertencia Catalog Numbers PC1800HD Form # April Especificaciones
Top Page Image Contents