23.Pay attention to the risk of fire from sparks and heat. When there are no local fire prevention regulations for drilling, cutting or grinding machines, apply the regulations for arc welding.
24.Keep the workplace well lit.
25.Avoid all physical contact with earthed surfaces.
26.Stand firmly with good balance when drilling.
27.Always switch off the machine before attempting to move it.
28.Keep the workplace clean and in good order.
29.Check that the equipment is well anchored before you start to drill.
30.Always maintain the equipment well. Keep the equipment and machine free from dirt and well lubricated for safe and good machine performance.
31.Note: When
32.Always use a water collector.
warning!
Always wear approved protective clothing and approved safety equipment. Protective clothing and protective equipment cannot eliminate the risk of accidents but wearing proper clothing and the correct equipment will reduce the gravity of any injury should an accident occur. Ask your dealer about approved and recommended protective clothing and protective equipment.
WARNING!
Under no circumstances may the original design of this equipment be modified without the permission of the manufacturer. Unapproved modifications can result in serious personal injury or even death.
warning!
The equipment can be dangerous if used improperly or without due care and can lead to serious accidents, in the worst cases even fatal accidents. It is very important that you read this Operator’s Manual and understand the instructions before you attempt to use the equipment.
Important!
DS 40 Gyro is only designed for
Page 19 Fig. 6
Page 23 Fig. 14
11