Storage Recommendations, Charging Procedure

90565382 SSL16 SSL20 NEW Smart Select.qxd:??????-00 BDL500 laser 6/3/10 1:40 PM Page 6

	Recommended Minimum Wire Size for Extension Cords
Total Length of Cord
25 ft.	50 ft.	75 ft.	100 ft.	125 ft.	150 ft.	175 ft.
7.6 m	15.2 m	22.9 m	30.5 m	38.1 m	45.7 m	53.3 m
Wire Size AWG
18	18	16	16	14	14	12

•Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is ventilated through slots in the top and the bottom of the housing.

•Do not mount charger on wall or permanently affix charger to any surface. The charger is intended to use on a flat, stable surface (i.e., table top, bench top).

•Do not operate charger with damaged cord or plug — have them replaced immediately.

•Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to an authorized service center.

•Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.

•Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack will not reduce this risk.

•NEVER attempt to connect 2 chargers together.

•The charger is designed to operate on standard household electrical power (120 Volts). Do not attempt to use it on any other voltage.

SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTION FOR BATTERY PACKS

WARNING: For safe operation, read this manual and manuals originally supplied with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.

READ ALL INSTRUCTIONS

•Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire. Toxic fumes and materials are created when battery packs are burned.

•Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

•If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte for Li-ion batteries is composed of a mixture of liquid organic carbonates and lithium salts.

•Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

•Charge the battery packs only in Black & Decker chargers.

•DO NOT splash or immerse in water or other liquids. This may cause premature cell failure.

•Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in summer).

WARNING: Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling.

WARNING: Fire hazard. Do not store or carry battery so that metal objects can contact exposed battery terminals. For example, do not place battery in aprons, pockets, tool boxes, product kit boxes, drawers, etc., with loose nails, screws, keys, etc.

Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes (i.e., packed in suitcases and carry-on luggage) UNLESS they are properly protected from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit. NOTE: LI-ION batteries should not be put in checked baggage.

STORAGE RECOMMENDATIONS

1.The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold.

2.Long storage will not harm the battery pack or charger.

CHARGING PROCEDURE

Black & Decker chargers are designed to charge

Black & Decker battery packs in 5-8 hours depending A on the pack being charged.

1.Plug the charger into an appropriate outlet before inserting the battery pack.

2.Insert the battery pack into the charger as shown in

figure A.

3. The green LED will flash indicating that the battery is being charged.

4.The completion of charge is indicated by the green LED remaining on continuously. The pack is fully charged and may be used at this time or left on the charger.

Recharge discharged batteries as soon as possible after use or battery life may be greatly diminished. For longest battery life, do not discharge batteries fully. It is recommended that the batteries be recharged after each use.

CHARGER DIAGNOSTICS

This charger is designed to detect certain problems that can arise with the battery packs or the power source. Problems are indicated by one LED flashing in different patterns.

BAD BATTERY

The charger can detect a weak or damaged battery. The red LED flashes in the pattern indicated on the label. If you see this bad battery blink pattern, do not continue to charge the battery. Return it to a service center or a collection site for recycling.

HOT/COLD PACK DELAY

When the charger detects a battery that is excessively hot or excessively cold, it automatically starts a Hot/Cold Pack Delay, suspending charging until the battery has normalized. After this happens, the charger automatically switches to the Pack Charging mode. This feature ensures maximum battery life. The red LED flashes in the pattern indicated on the label.

LEAVING THE BATTERY IN THE CHARGER

The charger and battery pack can be left connected with the green LED glowing indefinitely. The charger will keep the battery pack fresh and fully charged.

IMPORTANT CHARGING NOTES

1.Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between 65°F and 75°F (18°- 24°C). DO NOT charge the battery pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important and will prevent serious damage to the battery pack.

2.The charger and battery pack may become warm to touch while charging. This is a normal condition, and does not indicate a problem. To facilitate the cooling of the battery

SSL20, SSL16 specifications

The Black & Decker SSL16, SSL20, SSL20SBR, and SSL16 (16V MAX*) series represent a significant innovation in the realm of cordless tools and outdoor equipment, particularly in the domain of battery-powered lawn and garden maintenance. These models showcase a seamless blend of advanced technology, user-friendly design, and robust performance, catering to both homeowners and professionals alike.

The SSL16 model is powered by a 16V MAX lithium-ion battery, which provides reliable and consistent power for a range of applications. This ensures that users experience minimal downtime, as the battery is engineered for longer runtime and quicker charging than traditional batteries. Its lightweight design enhances maneuverability, making it an excellent option for trimming and shaping hedges or small bushes.

Moving to the SSL20 and SSL20SBR, both models elevate the performance with an enhanced 20V MAX lithium-ion battery. This increased power translates to greater efficiency and the ability to tackle larger, more demanding tasks with ease. The SSL20SBR model features a brushless motor, reducing wear and tear while delivering superior performance. Brushless technology not only extends the tool’s lifespan but also maximizes runtime and efficiency, offering users a powerful cutting experience while minimizing maintenance needs.

One standout feature across the series is the ergonomic design, including soft-grip handles that reduce user fatigue during prolonged use, making these tools comfortable to operate. The tools also come equipped with an adjustable cutting width, enabling users to adapt their approach to different gardening tasks. This feature allows for precise trimming, ensuring that users can achieve the desired look for their lawns and gardens.

The Black & Decker SSL series also emphasizes user safety with integrated safety features, including a safety lock to prevent accidental starts. Coupled with a lightweight design, these tools ensure that users can maintain control and comfort, even in challenging working conditions.

In summary, the Black & Decker SSL16, SSL20, SSL20SBR, and SSL16 (16V MAX*) models showcase a remarkable fusion of power, versatility, and usability. From their advanced battery technologies to user-oriented features, these tools stand out in the market, offering gardeners and landscapers the reliability and efficiency they need to achieve professional results. Whether tackling small projects or larger landscaping endeavors, these models are built to perform, making them an excellent addition to any tool collection.