Hitachi DV18DMR, DV14DMR instruction manual Loosen

English

CAUTION:

●Do not attach the tip tool except phillips bit to the tool main unit when carrying the tool main unit with the hook suspended from a waist belt.

Injury may result if you carry the equipment suspended from the waist belt with sharp

tipped components such as drill bit attached.		4	5
The hook can be installed on the right or left side		3
	2
and the angle can be adjusted in 5 steps between			(A)
		(B)
0° and 80°.	1		Hook
(1) Operating the hook
(a) Pull out the hook toward you in the direction
of arrow (A) and turn in the direction of arrow		Fig. 7
(B). (Fig. 7)

(b)The angle can be adjusted in 5 steps (0°, 20°, 40°, 60°, 80°).

Adjust the angle of the hook to the desired
position for use.
(2) Switching the hook position	Loosen
CAUTION:

● If the tool falls, there is a risk that malfunction and/	Screw
or physical damage can occur. It is recommended
that you also use fall-preventing wires, etc.	Fig. 8

●Incomplete installation of the hook may result in

	bodily injury when used.
	(a)	Securely hold the main unit and remove the
		screw using a slotted head screwdriver or a
		coin. (Fig. 8)	Hook
	(b)	Remove the hook and spring. (Fig. 9)
	(c) Install the hook and spring on the other side		Spring
		and securely fasten with screw. (Fig. 8)
			Fig. 9
NOTE:
	Pay attention to the spring orientation. Install the spring
	with larger diameter away from you. (Fig. 10)
1.1	Using the bit holder (Hook with bit holder)
◯	Installing the bit		Screw
	Slide the bit from the side, and then insert firmly
	until the groove on the bit locks in the protruded		Larger diameter faces away
	section of the hook.		Fig. 10

◯Removing the bit

Securely hold the main unit and pull out the bit by holding the tip with your thumb. (Fig. 11)

CAUTION:

● Only Hitachi STANDARD ACCESSORIES phillips bit (No. 2 ⋅ 65L; Code No. 983006) may be used.

Do not use other bits since they may come loose.

20 Fig. 11