Sharp KC-830U operation manual Rinse the Humidifying Tray with lukewarm wa- ter

Insert the tab of the float into the hole.

HUMIDIFYING TRAY

		Frequency of maintenance cycle will depend on the hardness
Care Cycle	1 month
		of the water. Avoid spilling water when removing or cleaning
		the tray.

1 Remove the Water Tank and Humidifying Tray.

Unlatch the Water Tank first, then re- move the tray. Use both hands when pulling out the Hu- midifying Tray to avoid spilling water.

2 Remove the Humidifying filter from the Humidifying Tray. Drain accumulated wa- ter by tilting the Humidifying Tray slowly.

Humidifying filter

Humidifying Tray

3 Rinse the inside of the Humidifying Tray with lukewarm water to remove impurities.

•Do not remove the Styrofoam float.

•Clean difficult-to-reach parts with a cotton- tipped swab or tooth brush.

If the Styrofoam float comes off, replace by inserting the tabs of the Float into the holes in the Humidifying Tray as shown in the diagram.

When Water Deposits are Difficult to Remove

1 Fill Humidifying Tray half- way with lukewarm water, add a small amount of mild kitchen detergent, and leave to soak for about 30 min- utes.

Dilute detergent according to instructions on the container. Clean difficult-to-reach parts with a cotton swab or tooth brush.

2 Rinse the Humidifying Tray with lukewarm wa- ter.

•Rinse until all detergent residue is removed.

•Inadequate rinsing may cause the detergent odor or changes in the shape/color of the main unit.

CAUTION

•Use only mild kitchen detergents to clean the Humidifying Tray. Use of non-designated chemicals or deter- gents can cause deformation, tar- nishing, cracking (water leakage).

Insert the float below this tab.

Insert the tab on the other side of the float into the hole.

ENGLISH

E-15