Vibrator module
Description | Spare part number |
|
|
Vibrator module (includes left and right vibrator modules and cables) | |
|
|
Before removing the vibrator module, follow these steps:
1.Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the slate.
3.Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the slate.
4.Remove the display panel assembly (see Display panel assembly on page 32).
5.Remove the battery (see Battery on page 36).
Remove the vibrator module:
1.Disconnect the vibrator module cable (1) from the docking connector board.
2.Release the vibrator module cables from the retention tabs (2) built into the bottom cover.
3.Detach the vibrator module (3) from the bottom cover. (The vibrator module is attached to the bottom cover with
4.Remove the vibrator module.
Reverse this procedure to install the vibrator module.
42 Chapter 5 Removal and replacement procedures – slate