HP x2 1011 G1 manual Rear-facing webcam

Rear-facing webcam

NOTE: The rear-facing webcam is included in the Webcam Kit, spare part number 793724-001.

The rear-facing webcam spare part kit does not include the rear-facing webcam cable. The rear-facing webcam cable is included in the Slate Cable Kit, spare part number 793721-001.

Before removing the rear-facing webcam, follow these steps:

1.Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the slate.

3.Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the slate.

4.Remove the display panel assembly (see Display panel assembly on page 32), and then remove the following components:

a.Battery (see Battery on page 36)

b.WLAN module (see WLAN module on page 37)

c.WWAN module (see WWAN module on page 39)

d.Fan (see Fan on page 43)

e.System board (see System board on page 49)

Remove the rear-facing webcam:

1.Turn the system board upside down with the top edge toward you.

2.Disconnect the rear-facing webcam cable (1) from the front-facing webcam board.

3.Remove the rear-facing webcam (2).

Reverse this procedure to install the rear-facing webcam.

Rear-facing webcam 61