HP x2 1011 G1 manual Smart card reader board 793711-001

3.Remove the TouchPad (3).

Reverse this procedure to install the TouchPad.

Smart card reader board

Description	Spare part number
Smart card reader board	793711-001
NOTE: The smart card reader board spare part kit does not include the smart card reader board cable.
The smart card reader board cable is included in the Keyboard Base Cable Kit, spare part number
793721-001.

Before removing the smart card reader board, follow these steps:

1.Shut down the keyboard base. If you are unsure whether the keyboard base is off or in Hibernation, turn the keyboard base on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the keyboard base.

3.Disconnect the power from the keyboard base by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the keyboard base.

4.Remove the bottom cover (see Bottom cover on page 71).

5.Remove the battery (see Keyboard base battery on page 72).

Remove the smart card reader board:

1.Disconnect the TouchPad cable from the LIF connector (1) on smart card reader board.

2.Release the ZIF connector (2) to which the smart card reader board cable is attached, and then disconnect the smart card reader board cable from the keyboard base connector board.

Smart card reader board 79