HP x2 1011 G1 manual Wlan antenna

WLAN antenna

NOTE: The WLAN main antenna is included in the Antenna Kit, using the following spare part numbers:

●805065-001 – For use in African, European, and Middle Eastern countries and regions

●806251-001 – For use in Japan

●805067-001 – For use in North America

Before removing the WLAN antenna, follow these steps:

1.Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the slate.

3.Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the slate.

4.Remove the display panel assembly (see Display panel assembly on page 32), and then remove the following components:

a.Battery (see Battery on page 36)

b.WLAN module (see WLAN module on page 37)

c.WWAN module (see WWAN module on page 39)

d.Fan (see Fan on page 43)

e.System board (see System board on page 49)

Remove the WLAN antenna:

1.Release the WLAN antenna cable from the retention tabs (1) built into the bottom cover.

2.Remove the WLAN antenna (2) transceiver and cable.

WLAN antenna 67