HP x2 1011 G1 manual Docking connector board cable

3.Remove the WiGig antenna (3) cable and transceiver.

Reverse this procedure to install the WiGig antenna.

Docking connector board cable

NOTE: The docking connector board cable is included in the Slate Cable Kit, spare part number 793721-001.

Before removing the docking connector board cable, follow these steps:

1.Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the slate.

3.Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the slate.

4.Remove the display panel assembly (see Display panel assembly on page 32), and then remove the following components:

a.Battery (see Battery on page 36)

b.WLAN module (see WLAN module on page 37)

c.WWAN module (see WWAN module on page 39)

d.Fan (see Fan on page 43)

e.Docking connector board (see Docking connector board on page 46)

f.System board (see System board on page 49)

Remove the docking connector board cable:

1.Detach the docking connector board cable (1) from the bottom cover. (The docking connector board cable is attached to the bottom cover with double-sided adhesive.)

Docking connector board cable 69