Reverse this procedure to install the WLAN antenna.
WiGig antenna
Description | Spare part number |
|
|
WiGig antenna (includes WiGig antenna cable and transceiver) | |
|
|
Before removing the WiGig antenna, follow these steps:
1.Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the slate.
3.Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the slate.
4.Remove the display panel assembly (see Display panel assembly on page 32), and then remove the following components:
a.Battery (see Battery on page 36)
b.WLAN module (see WLAN module on page 37)
c.WWAN module (see WWAN module on page 39)
d.Fan (see Fan on page 43)
e.System board (see System board on page 49)
Remove the WiGig antenna:
1.Detach the WiGig antenna transceiver (1) from the bottom cover. (The WiGig antenna transceiver is attached to the bottom cover with
2.Release the WiGig antenna cable from the retention tabs (2) built into the bottom cover.
68 Chapter 5 Removal and replacement procedures – slate