HP Server tc2110 manual Installing a Second Hard Disk Drive Drive Cage Mounted

Page 29

Chapter 3

Installing and Configuring

The HP Server tc2110 will support an HP NetRAID 1M controller board, separate from the SCSI controller board.

SCSI Mass Storage Additions

Table 3-2 lists the number and types of mass storage devices that may be added to the SCSI model of the HP Server.

Table 3-2. SCSI Model Mass Storage Devices

Interface

Max No.

Types

Devices

FDD

1

IDE-2

2*

Internal SCSI

4***

cable

 

(Ultra-160

 

SCSI Adapter)

 

External SCSI

15***

connector

 

(Ultra-160

 

SCSI Adapter)

 

Installed Devices and Addresses

Factory installed flexible disk drive (FDD) in shelf 1

￿￿Factory installed CD-ROM drive in shelf 2

￿￿A second IDE device could be installed, if shelf 3 is available.

￿￿Factory installed SCSI HDD (shelf 5, address = ID 0

￿￿Optional 2nd SCSI HDD (shelf 6, addresses = ID 1).

￿￿Optional 3rd SCSI HDD (shelf 4, address = ID 2)

￿￿Optional SCSI Tape Backup Drive (shelf 3, address = ID 3) **

￿￿￿SCSI controller (address = ID 7)

￿￿Only used for control of external SCSI devices. This SCSI connector can control up to 15 external SCSI devices.

*The secondary IDE (IDE-2) cable is connected to the factory-installed CD-ROM drive. The primary IDE connector (IDE-1) is available on the SCSI model, but is not supported by Hewlett-Packard.

**A 50-to-68-pin SCSI adapter is provided with the HP backup tape drive.

***The single channel SCSI controller can support up to 15 devices on one connector at a time; however, there are only enough internal storage shelves for 3 hard drives and 1 optional backup tape device. The external connector is only used to control external SCSI devices when there are no internal SCSI devices.

Installing a Second Hard Disk Drive (Drive Cage Mounted)

The first hard disk drive (IDE or SCSI) is always mounted in the top (shelf 5) of the hard disk drive cage. The second hard disk drive should be mounted just below it (shelf 6).

1.If the Server is already installed and operating, power down the Server. Refer to Chapter 1, “Controls and Indicators.”

2.Disconnect the power cables and any external cables connected to the Server. If necessary, label each one to expedite re-assembly.

3.Remove the side cover from the Server.

Refer to “Opening and Closing the HP Server” earlier in this chapter.

4.Press and release the retaining clips at the sides of the drive cage. See Figure 3-6.

23

Image 29
Contents HP Server tc2110 Operations and Maintenance Guide Audience Assumptions Contents Contents Error! Bookmark not definedServer stops working hangs 109 105Front Panel Controls and IndicatorsSleep LED Additional Controls and IndicatorsRear Panel Connecting the Power Cords Applying Power to the HP ServerConnecting the Power Cords Powering-Up the ServerSetting the input voltage Sleep States Acpi Powering-Down the ServerConnecting Power to Multiple-Server Configurations Chapter Page Serial Port Connector External ConnectorsMini-DIN PS/2 Connectors USB Connector Parallel Port ConnectorPin 1 LVD Scsi Connector Male Pin LVD Scsi Port Connector Low Voltage DifferentialPosition Pin Narrow Scsi Port Connector Accessory BoardStandard LAN Connector Page Removing the Left Side Cover Installing and ConfiguringOpening and Closing the HP Server Removing the Left Side Cover Replacing the Left Side CoverReplacing the Left Side Cover Removing the Upper BezelRemoving the Upper Front Bezel Replacing the Upper BezelReplacing the Upper Bezel Mass StorageMass Storage Locations Mass Storage GuidelinesIDE Mass Storage Devices Boot PriorityIDE Controller Configuration IDE Mass Storage Additions Scsi Controller ConfigurationScsi Mass Storage Devices Scsi Mass Storage Additions Installing a Second Hard Disk Drive Drive Cage MountedReleasing the Retaining Clips Drive Cage Mounting Installing a Third Hard Disk Drive Tray MountedInstalling a Disk Drive Tray Mounted Installing an Optional CD-ROM or DVD Drive10. Installing an Optional CD-ROM or DVD Drive Installing an Optional Backup Tape Drive Tools Required Memory Installation GuidelinesMemory Modules Installing Additional DIMMs 12. Dimm Locations on System Board Removing DIMMs Processor15. Removing Heat Sink and Cooling Fan Removing the Heat Sink and Cooling FanReplacing the Processor Removing the Processor17. Replacing the Processor Replacing the Heat Sink and Cooling FanTested PCI Boards Accessory BoardsGuidelines IRQ SettingsInstalling an Accessory Board Particular accessory board type 21. Removing the Slot Cover Removing Accessory Boards Connecting Peripheral DevicesMonitor, Keyboard, and Mouse Uninterruptible Power Supply UPSHP Startup CD-ROM Configuring the HP Server tc2110Accessing the HP Startup CD-ROM Contents of the HP Startup CD-ROM Bios Setup UtilityNOS Installation DiagtoolsMenu Bar Accessing the Setup UtilityViewing the Summary Configuration Screen Changing the System Date and Time Using the Setup ScreensSetting Boot Passwords Scsi Configuration Utility Power-On Self Test Post DiagnosticsPost Error Messages No Error Messages DisplayedAfter Installing an Accessory General ChecksClearing the Cmos and Passwords Location of Configuration Switches HP Diagtools Capabilities HP Server DiagtoolsAdvantages and Limitations of Hardware Diagnostics About Error MessagesHP Toptools Some limitations areBeep Codes Error MessagesPower-On Self Test Post Error Messages Troubleshooting Tools Maintenance and TroubleshootingPreventive Maintenance Procedures Other Support Information TroubleshootingTroubleshooting Checklist Bios Update/Recovery Bios Reset/Update/RecoveryBios Reset Clearing the Bios Configuration Password ProblemsSupervisor Password User PasswordOperating System Not Found Message Appears Configuration and Password Switch LocationServer Stops or Hangs While Starting Up Power ProblemsVideo/Monitor Problems Printer Problems Configuration ProblemsMouse Does Not Work Keyboard Does Not WorkEnvironmental problems result from Flexible Disk and Flexible Disk Drive ProblemsFlexible Disk Drive Problems CD-ROM Drive is Not Working Properly CD-ROM ProblemsCD-ROM Drawer Will Not Open Scsi Controller Does Not Work At Initial Installation Scsi ProblemsServer Will Not Boot From a CD-ROM Disk Scsi Device Stops Working Scsi Device Does Not Work After InstallationMemory Problems Processor ProblemsNetwork Interface Card embedded or PCI Problems LEDs are not lit on the NIC Service Tools Required Replacing PartsSafety Information Removing the Flexible Disk Drive Mass Storage DevicesRemoving the CD-ROM Replacing the Flexible Disk DriveRemoving the CD-ROM Replacing the CD-ROMReplacing a Backup Tape Drive Removing a Backup Tape DriveRemoving a Hard Disk Drive Tray Mounted Removing Hard Disk Drive HDD and Tray Replacing a Hard Disk Drive Tray MountedRemoving a Hard Disk Drive Drive Cage Mounted Replacing a Hard Disk Drive Drive Cage Mounted DIMMsRemoving DIMMs from System Board Replacing DIMMsDimm to Slot Alignment 10. Removing Heat Sink and Cooling Fan 11. Removing the Processor 12. Replacing the Processor 13. Replacing Heat Sink-Cooling Fan on the Processor 14. Removing Slot Cover Latch Replacing Accessory BoardsSlot Cover Removing the Power Supply Power SupplyRemoving the Battery BatteryReplacing the Power Supply Removing the Chassis Fan Replacing the BatteryChassis Fan 19. Removing the Chassis Fan Replacing the Chassis FanRemoving the System Board System Board20. Removing and Replacing the System Board Replacing the System BoardPage Exploded View Covers and Bezels Parts IdentificationExploded View Mass Storage Devices Exploded View Chassis Fan, Power Supply, and System Board Exploded View System Board Components Replaceable Parts List Cables and Part Numbers Keyboards Power CordsPage Weight and Dimensions SpecificationsPower Supply Specifications EnvironmentalIDE Hardware SpecificationsSystem Board Layout System Board Components/Connectors 107Page Acpi IndexKeyboards Part numbers Scsi ID ZIF
Related manuals
Manual 1 pages 3.34 Kb Manual 4 pages 49.92 Kb Manual 65 pages 57.66 Kb

Server tc2110 specifications

The HP Server tc2110 is a robust and versatile solution designed to meet the needs of small to medium-sized businesses looking for reliability and performance in their IT infrastructure. This server is built on the foundation of HP's renowned engineering, making it a trusted choice for organizations needing dependable server capabilities.

One of the standout features of the HP tc2110 is its scalability. With support for multiple processors, organizations can easily upgrade their server capabilities as their needs grow. This makes it an ideal choice for businesses that anticipate future expansion and require a server that can grow alongside them. The tc2110 supports various Intel Xeon processors, offering excellent processing power and efficiency.

Another significant characteristic of the tc2110 is its high capacity for memory. The server can support substantial RAM, which enhances its multitasking capabilities and allows it to handle demanding applications with ease. This memory capacity is complemented by the server's support for various storage options, including traditional hard drives and modern solid-state drives, enabling businesses to optimize performance and data access speeds according to their specific needs.

The HP Server tc2110 also emphasizes security features, which are critical for today’s evolving cybersecurity landscape. It includes advanced hardware security features such as Trusted Platform Module (TPM) and secure boot, ensuring that data is protected against unauthorized access and potential threats.

In addition to its impressive hardware capabilities, the tc2110 is designed with energy efficiency in mind. Its intelligent cooling technologies and power management features help reduce overall operational costs while maintaining optimal performance. This makes the server not only a powerful option but also a more environmentally friendly choice, aligning with the growing trend towards sustainable IT practices.

Connectivity is another key aspect of the HP tc2110. It offers multiple ports for network connections, ensuring seamless integration into existing IT infrastructures. This connectivity enhances communication between devices and provides businesses with the flexibility to adapt to new technology advancements with ease.

Overall, the HP Server tc2110 is a well-rounded server solution that combines performance, scalability, security, and energy efficiency. Whether for intensive applications, data management, or general computing tasks, the tc2110 stands out as a reliable choice for enterprises seeking to establish or enhance their IT environments. Its blend of features makes it a compelling option for organizations aiming to streamline operations while minimizing costs.