HP Server tc2110 manual Replacing the Flexible Disk Drive, Removing the CD-ROM

Page 81

Chapter 7

Replacing Parts

Figure 7-2. Removing the Flexible Disk Drive (FDD)

7.Remove the flexible disk drive from the tray.

8.Place the flexible disk drive in an anti-static bag.

Replacing the Flexible Disk Drive

1.If not already mounted, insert the new drive in the tray (pin side first), and then replace the side screws.

2.With the cable connectors toward the rear of the chassis, slide the FDD assembly all the way into the chassis, until the FDD assembly snaps into place.

The flexible disk drive is only mounted in the top shelf (shelf 1).

3.At the rear of the flexible disk drive, carefully connect the power and data cable.

4.Replace the upper bezel.

5.Replace the left side cover.

6.Replace the external cables and power cord.

7.Power on the Server as described in Chapter 1, “Controls and Indicators.”

Removing the CD-ROM

16.If the Server is operating, power down the Server.

Refer to Chapter 1, “Controls and Indicators” for instructions.

17.Disconnect the power cord and any external cables connected to the Server. If necessary, label each one to expedite re-assembly.

18.Remove the left side cover.

Refer to “Opening and Closing the HP Server” in Chapter 3.

19.Remove the upper bezel.

Refer to “Opening and Closing the HP Server” in Chapter 3.

20.At the rear of the CD-ROM, carefully disconnect the power and data cables.

21.Remove the CD-ROM:

Press in on both release tabs to release the CD-ROM tray assembly.

75

Image 81
Contents HP Server tc2110 Operations and Maintenance Guide Audience Assumptions Contents Contents Error! Bookmark not definedServer stops working hangs 109 105Front Panel Controls and IndicatorsSleep LED Additional Controls and IndicatorsRear Panel Connecting the Power Cords Applying Power to the HP ServerPowering-Up the Server Setting the input voltageConnecting the Power Cords Powering-Down the Server Connecting Power to Multiple-Server ConfigurationsSleep States Acpi Chapter Page External Connectors Mini-DIN PS/2 ConnectorsSerial Port Connector USB Connector Parallel Port ConnectorPin 1 LVD Scsi Connector Male Pin LVD Scsi Port Connector Low Voltage DifferentialPosition Pin Narrow Scsi Port Connector Accessory BoardStandard LAN Connector Page Installing and Configuring Opening and Closing the HP ServerRemoving the Left Side Cover Removing the Left Side Cover Replacing the Left Side CoverReplacing the Left Side Cover Removing the Upper BezelRemoving the Upper Front Bezel Replacing the Upper BezelReplacing the Upper Bezel Mass StorageMass Storage Locations Mass Storage GuidelinesBoot Priority IDE Controller ConfigurationIDE Mass Storage Devices Scsi Controller Configuration Scsi Mass Storage DevicesIDE Mass Storage Additions Scsi Mass Storage Additions Installing a Second Hard Disk Drive Drive Cage MountedReleasing the Retaining Clips Drive Cage Mounting Installing a Third Hard Disk Drive Tray MountedInstalling a Disk Drive Tray Mounted Installing an Optional CD-ROM or DVD Drive10. Installing an Optional CD-ROM or DVD Drive Installing an Optional Backup Tape Drive Memory Installation Guidelines Memory ModulesTools Required Installing Additional DIMMs 12. Dimm Locations on System Board Removing DIMMs Processor15. Removing Heat Sink and Cooling Fan Removing the Heat Sink and Cooling FanReplacing the Processor Removing the Processor17. Replacing the Processor Replacing the Heat Sink and Cooling FanTested PCI Boards Accessory BoardsGuidelines IRQ SettingsInstalling an Accessory Board Particular accessory board type 21. Removing the Slot Cover Removing Accessory Boards Connecting Peripheral DevicesMonitor, Keyboard, and Mouse Uninterruptible Power Supply UPSConfiguring the HP Server tc2110 Accessing the HP Startup CD-ROMHP Startup CD-ROM Contents of the HP Startup CD-ROM Bios Setup UtilityNOS Installation DiagtoolsAccessing the Setup Utility Viewing the Summary Configuration ScreenMenu Bar Changing the System Date and Time Using the Setup ScreensSetting Boot Passwords Scsi Configuration Utility Power-On Self Test Post DiagnosticsPost Error Messages No Error Messages DisplayedAfter Installing an Accessory General ChecksClearing the Cmos and Passwords Location of Configuration Switches HP Diagtools Capabilities HP Server DiagtoolsAdvantages and Limitations of Hardware Diagnostics About Error MessagesHP Toptools Some limitations areError Messages Power-On Self Test Post Error MessagesBeep Codes Maintenance and Troubleshooting Preventive Maintenance ProceduresTroubleshooting Tools Other Support Information TroubleshootingTroubleshooting Checklist Bios Reset/Update/Recovery Bios ResetBios Update/Recovery Clearing the Bios Configuration Password ProblemsSupervisor Password User PasswordOperating System Not Found Message Appears Configuration and Password Switch LocationServer Stops or Hangs While Starting Up Power ProblemsVideo/Monitor Problems Printer Problems Configuration ProblemsMouse Does Not Work Keyboard Does Not WorkFlexible Disk and Flexible Disk Drive Problems Flexible Disk Drive ProblemsEnvironmental problems result from CD-ROM Problems CD-ROM Drawer Will Not OpenCD-ROM Drive is Not Working Properly Scsi Problems Server Will Not Boot From a CD-ROM DiskScsi Controller Does Not Work At Initial Installation Scsi Device Stops Working Scsi Device Does Not Work After InstallationMemory Problems Processor ProblemsNetwork Interface Card embedded or PCI Problems LEDs are not lit on the NIC Replacing Parts Safety InformationService Tools Required Removing the Flexible Disk Drive Mass Storage DevicesRemoving the CD-ROM Replacing the Flexible Disk DriveRemoving the CD-ROM Replacing the CD-ROMReplacing a Backup Tape Drive Removing a Backup Tape DriveRemoving a Hard Disk Drive Tray Mounted Removing Hard Disk Drive HDD and Tray Replacing a Hard Disk Drive Tray MountedRemoving a Hard Disk Drive Drive Cage Mounted Replacing a Hard Disk Drive Drive Cage Mounted DIMMsRemoving DIMMs from System Board Replacing DIMMsDimm to Slot Alignment 10. Removing Heat Sink and Cooling Fan 11. Removing the Processor 12. Replacing the Processor 13. Replacing Heat Sink-Cooling Fan on the Processor 14. Removing Slot Cover Latch Replacing Accessory BoardsSlot Cover Removing the Power Supply Power SupplyBattery Replacing the Power SupplyRemoving the Battery Replacing the Battery Chassis FanRemoving the Chassis Fan 19. Removing the Chassis Fan Replacing the Chassis FanRemoving the System Board System Board20. Removing and Replacing the System Board Replacing the System BoardPage Exploded View Covers and Bezels Parts IdentificationExploded View Mass Storage Devices Exploded View Chassis Fan, Power Supply, and System Board Exploded View System Board Components Replaceable Parts List Cables and Part Numbers Keyboards Power CordsPage Weight and Dimensions SpecificationsPower Supply Specifications EnvironmentalIDE Hardware SpecificationsSystem Board Layout System Board Components/Connectors 107Page Acpi IndexKeyboards Part numbers Scsi ID ZIF
Related manuals
Manual 1 pages 3.34 Kb Manual 4 pages 49.92 Kb Manual 65 pages 57.66 Kb

Server tc2110 specifications

The HP Server tc2110 is a robust and versatile solution designed to meet the needs of small to medium-sized businesses looking for reliability and performance in their IT infrastructure. This server is built on the foundation of HP's renowned engineering, making it a trusted choice for organizations needing dependable server capabilities.

One of the standout features of the HP tc2110 is its scalability. With support for multiple processors, organizations can easily upgrade their server capabilities as their needs grow. This makes it an ideal choice for businesses that anticipate future expansion and require a server that can grow alongside them. The tc2110 supports various Intel Xeon processors, offering excellent processing power and efficiency.

Another significant characteristic of the tc2110 is its high capacity for memory. The server can support substantial RAM, which enhances its multitasking capabilities and allows it to handle demanding applications with ease. This memory capacity is complemented by the server's support for various storage options, including traditional hard drives and modern solid-state drives, enabling businesses to optimize performance and data access speeds according to their specific needs.

The HP Server tc2110 also emphasizes security features, which are critical for today’s evolving cybersecurity landscape. It includes advanced hardware security features such as Trusted Platform Module (TPM) and secure boot, ensuring that data is protected against unauthorized access and potential threats.

In addition to its impressive hardware capabilities, the tc2110 is designed with energy efficiency in mind. Its intelligent cooling technologies and power management features help reduce overall operational costs while maintaining optimal performance. This makes the server not only a powerful option but also a more environmentally friendly choice, aligning with the growing trend towards sustainable IT practices.

Connectivity is another key aspect of the HP tc2110. It offers multiple ports for network connections, ensuring seamless integration into existing IT infrastructures. This connectivity enhances communication between devices and provides businesses with the flexibility to adapt to new technology advancements with ease.

Overall, the HP Server tc2110 is a well-rounded server solution that combines performance, scalability, security, and energy efficiency. Whether for intensive applications, data management, or general computing tasks, the tc2110 stands out as a reliable choice for enterprises seeking to establish or enhance their IT environments. Its blend of features makes it a compelling option for organizations aiming to streamline operations while minimizing costs.