HP 670C manual Clean the Service Station, Reinstall the Print Cartridges

SECTION THREE

••••••••••••••••••••••••••••••••••••••••••••••••••• ••••••••••••••••••••••••••••••••••••••••••••••••••• ••••••••••••••••••••••••

Clean the Service Station

1.Using a clean, moistened swab, clean the rim of the sponge holder.

2.Remove any built-up ink and fibers from the top of the sponge. If the sponge is higher than the rim, use the cotton swab to push it below the rim.

3.Using a clean, moistened swab, clean wiper 1 and the top surface of cap 1.

C A U T I O N

Use a light force when cleaning the print cartridge caps. A heavy force may unseat the caps, eventually causing damage to the print cartridges.

4.Using a clean, moistened swab, clean wiper 2 and the top surface of cap 2.

Cap 2

Wiper 2

Cap 1

Wiper 1

Sponge

Rim

7539-13

Reinstall the Print Cartridges

1.Reinstall the print cartridges and close the printer’s top cover.

2.Reinsert the power cord into the back of the printer.

3.Print a self-test page. On the Printer Services tab of the HP Toolbox, click the Print a self-test page button.

4.Examine the printout for ink streaking.

N O T E

This procedure should remove all fibers that would cause ink to streak on a print- out; however, it is possible that fibers may have been missed. If the printout still shows streaking, repeat the procedure until the self-test printout is clear and sharp. It is recommended that you perform this cleaning every 3 months. This procedure and additional maintenance tips are located on the Would Wide Web at http://www.deskjet-support.com/maintenance.

••••••••••••••••••••••••••••••••••••••••••••••••••• ••••••••••••••••••••••••••••••••••••••••••••••••••• ••••••••••••••••••••••••

50