HP R5500 manual Installation

Page 13

WARNING: To reduce the risk of personal injury or damage to the equipment, be sure that:

•The leveling feet are extended to the floor.

•The full weight of the rack rests on the leveling feet.

•The stabilizing feet are attached to the rack if it is a single-rack installation.

•The racks are coupled together in multiple-rack installations.

•Only one component is extended at a time. A rack may become unstable if more than one component is extended for any reason.

NOTE: Mounting hardware for square- and round-holed racks is included in the UPS kit.

1.Loosen the hex nuts, and extend the brackets to the desired length.

2.Insert screws through the rack into the mounting rail and the front of each mounting bracket.

Installation 13

Image 13

Contents Part Number 351643-004A September 2007 Fourth Edition HP UPS R5500 User GuideAudience assumptions Contents Power management software Verifying the Repo port connection Powering down the UPSOrdering spares Before you contact HP HP contact information UPS spare parts list Hardware optionsUPS R5500 overview Component identificationUPS front panel DescriptionUPS front panel controls Powers up the UPS Starting power toFront panel is shown with the bezel removed LED description UPS front panel LED indicatorsRepo port UPS rear panelERM rear panel Precautions InstallationPreparing to install the hardware Tools and materialsSelecting a site Installing the mounting railsReadying the equipment Installation Installation Preparing the rails for integrated shipping Installing the UPSTighten the hex nuts Installation Removing the UPS battery bracket Installing the batteries Installation Installation Connecting the Repo port Connecting the ground bonding cable Connecting devices to the UPS Connecting the UPS to utility powerGround bonding cable is not included Installation Starting power to the load Installing the ERMInstallation Installation Operate mode Standby modeUPS operations Modes of operationConfigure mode Configuring the UPSAuto-Bypass mode Explanation when LED is illuminatedAvailable settings Parameter Testing the LEDsPowering down the UPS Silencing an audible alarmVerifying the Repo port connection Power management software Power managementRemoving the UPS front bezel Removing the ERM front bezel MaintenanceReplacing the UPS electronics module Replacing the UPS option card Battery care and storage guidelines Important battery safety informationTo replace the component, reverse the removal procedure Replacing the batteriesUPS battery replacement procedure Replacing the ERM Replacing the UPSUpdating the UPS firmware LED and audible alarm troubleshooting TroubleshootingAlarm Be silenced 30?General alarm condition Battery conditionBypass is out of range Input voltage is not within ±12 percent of nominal voltageLow battery shutdowns Internal UPS fault conditionInput voltage is out of range Insufficient warning of low batteriesUPS does not provide the expected backup time Site wiring conditionOverload condition Repo conditionUPS is in Auto-Bypass mode UPS frequently switches between utility and battery powerUPS is on battery Utility power conditionUPS physical specifications SpecificationsERM physical specifications UPS input specificationsVoltage specifications Power protection specificationsUPS model Nominal power Rating W Voltage setting Configuration setting VAC Available nominal output voltageBattery runtime for NA/JPN model Battery specificationsBattery runtime for Intl model Output tolerance specificationsRepo port specifications Environmental specificationsSpares UPS spare parts listOrdering spares Description Spare part NumberHardware options Before you contact HP Technical supportHP contact information Limited warranty Warranty information$250,000 Computer Load Protection Guarantee Pre-Failure Battery WarrantyRegulatory compliance identification numbers Regulatory compliance noticesFederal Communications Commission notice Cables ModificationsEuropean Union regulatory notice Canadian notice Avis CanadienJapanese notice Bsmi notice Battery replacement notice Power cord statement for Japan Taiwan battery recycling noticePreventing electrostatic discharge Electrostatic dischargeGrounding methods to prevent electrostatic discharge Acronyms and abbreviations Index Communications port, connectingInstallation instructions Repo port, connecting

Related manuals

Manual 61 pages 9.34 Kb