HP R5500 manual Environmental specifications, Repo port specifications

Page 47

Load, W (percent)	Estimated battery	Runtime with one ERM	Runtime with two ERMs
	runtime (minutes)	(minutes)	(minutes)

50	15	49	85

80	7	25	48

100	5	19	36

Environmental specifications

Feature	Specification

Operating temperature	10°C to 40°C (50°F to 104°F); UL-tested at 25°C
	(77°F)

Nonoperating	-25°C to 55°C (-13°F to 131°F)
temperature

Relative humidity	20% to 80%; noncondensing

Operating altitude	Up to 2,000 m (6,600 ft) above sea level

Nonoperating altitude	15,000 m (49,212 ft) above sea level

Audible noise	Less than 45 dBA, normal operation
	Less than 50 dBA, on battery power

REPO port specifications

The REPO port meets the requirements of NFPA Articles 645-10 and 645-11 for a Disconnecting Means.

Specifications 47

Image 47

Contents Part Number 351643-004A September 2007 Fourth Edition HP UPS R5500 User GuideAudience assumptions Contents Ordering spares Verifying the Repo port connection Powering down the UPSPower management software Before you contact HP HP contact information UPS spare parts list Hardware optionsDescription Component identificationUPS R5500 overview UPS front panelUPS front panel controls Powers up the UPS Starting power toFront panel is shown with the bezel removed LED description UPS front panel LED indicatorsRepo port UPS rear panelERM rear panel Tools and materials InstallationPrecautions Preparing to install the hardwareReadying the equipment Installing the mounting railsSelecting a site Installation Installation Tighten the hex nuts Installing the UPSPreparing the rails for integrated shipping Installation Removing the UPS battery bracket Installing the batteries Installation Installation Connecting the Repo port Connecting the ground bonding cable Ground bonding cable is not included Connecting the UPS to utility powerConnecting devices to the UPS Installation Starting power to the load Installing the ERMInstallation Installation Modes of operation Standby modeOperate mode UPS operationsExplanation when LED is illuminated Configuring the UPSConfigure mode Auto-Bypass modeAvailable settings Parameter Testing the LEDsVerifying the Repo port connection Silencing an audible alarmPowering down the UPS Power management software Power managementRemoving the UPS front bezel Removing the ERM front bezel MaintenanceReplacing the UPS electronics module Replacing the UPS option card Replacing the batteries Important battery safety informationBattery care and storage guidelines To replace the component, reverse the removal procedureUPS battery replacement procedure Replacing the ERM Replacing the UPSUpdating the UPS firmware 30? TroubleshootingLED and audible alarm troubleshooting Alarm Be silencedInput voltage is not within ±12 percent of nominal voltage Battery conditionGeneral alarm condition Bypass is out of rangeInsufficient warning of low batteries Internal UPS fault conditionLow battery shutdowns Input voltage is out of rangeRepo condition Site wiring conditionUPS does not provide the expected backup time Overload conditionUtility power condition UPS frequently switches between utility and battery powerUPS is in Auto-Bypass mode UPS is on batteryUPS input specifications SpecificationsUPS physical specifications ERM physical specificationsConfiguration setting VAC Available nominal output voltage Power protection specificationsVoltage specifications UPS model Nominal power Rating W Voltage settingOutput tolerance specifications Battery specificationsBattery runtime for NA/JPN model Battery runtime for Intl modelRepo port specifications Environmental specificationsDescription Spare part Number UPS spare parts listSpares Ordering sparesHardware options HP contact information Technical supportBefore you contact HP Pre-Failure Battery Warranty Warranty informationLimited warranty $250,000 Computer Load Protection GuaranteeFederal Communications Commission notice Regulatory compliance noticesRegulatory compliance identification numbers Cables ModificationsEuropean Union regulatory notice Canadian notice Avis CanadienJapanese notice Bsmi notice Battery replacement notice Power cord statement for Japan Taiwan battery recycling noticeGrounding methods to prevent electrostatic discharge Electrostatic dischargePreventing electrostatic discharge Acronyms and abbreviations Index Communications port, connectingInstallation instructions Repo port, connecting

Related manuals

Manual 61 pages 9.34 Kb