HP R5500 manual Canadian notice Avis Canadien, European Union regulatory notice

Page 54

Canadian notice (Avis Canadien)

Class A equipment

This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

Class B equipment

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

European Union regulatory notice

This product complies with the following EU Directives:

•Low Voltage Directive 2006/95/EC

•EMC Directive 2004/108/EC

Compliance with these directives implies conformity to applicable harmonized European standards (European Norms) which are listed on the EU Declaration of Conformity issued by Hewlett-Packard for this product or product family.

This compliance is indicated by the following conformity marking placed on the product:

This marking is valid for non-Telecom products and EU harmonized Telecom products (e.g. Bluetooth).

This marking is valid for EU non-harmonized Telecom products.

*Notified body number (used only if applicable—refer to the product label) Hewlett-Packard GmbH, HQ-TRE, Herrenberger Strasse 140, 71034 Boeblingen, Germany

This symbol on the product or on its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste equipment for recycling, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

Regulatory compliance notices 54

Image 54

Contents HP UPS R5500 User Guide Part Number 351643-004A September 2007 Fourth EditionAudience assumptions Contents Verifying the Repo port connection Powering down the UPS Power management softwareOrdering spares UPS spare parts list Hardware options Before you contact HP HP contact informationUPS front panel Component identificationUPS R5500 overview DescriptionPowers up the UPS Starting power to UPS front panel controlsUPS front panel LED indicators Front panel is shown with the bezel removed LED descriptionUPS rear panel Repo portERM rear panel Preparing to install the hardware InstallationPrecautions Tools and materialsInstalling the mounting rails Selecting a siteReadying the equipment Installation Installation Installing the UPS Preparing the rails for integrated shippingTighten the hex nuts Installation Removing the UPS battery bracket Installing the batteries Installation Installation Connecting the Repo port Connecting the ground bonding cable Connecting the UPS to utility power Connecting devices to the UPSGround bonding cable is not included Installation Installing the ERM Starting power to the loadInstallation Installation UPS operations Standby modeOperate mode Modes of operationAuto-Bypass mode Configuring the UPSConfigure mode Explanation when LED is illuminatedTesting the LEDs Available settings ParameterSilencing an audible alarm Powering down the UPSVerifying the Repo port connection Power management Power management softwareMaintenance Removing the UPS front bezel Removing the ERM front bezelReplacing the UPS electronics module Replacing the UPS option card To replace the component, reverse the removal procedure Important battery safety informationBattery care and storage guidelines Replacing the batteriesUPS battery replacement procedure Replacing the UPS Replacing the ERMUpdating the UPS firmware Alarm Be silenced TroubleshootingLED and audible alarm troubleshooting 30?Bypass is out of range Battery conditionGeneral alarm condition Input voltage is not within ±12 percent of nominal voltageInput voltage is out of range Internal UPS fault conditionLow battery shutdowns Insufficient warning of low batteriesOverload condition Site wiring conditionUPS does not provide the expected backup time Repo conditionUPS is on battery UPS frequently switches between utility and battery powerUPS is in Auto-Bypass mode Utility power conditionERM physical specifications SpecificationsUPS physical specifications UPS input specificationsUPS model Nominal power Rating W Voltage setting Power protection specificationsVoltage specifications Configuration setting VAC Available nominal output voltageBattery runtime for Intl model Battery specificationsBattery runtime for NA/JPN model Output tolerance specificationsEnvironmental specifications Repo port specificationsOrdering spares UPS spare parts listSpares Description Spare part NumberHardware options Technical support Before you contact HPHP contact information $250,000 Computer Load Protection Guarantee Warranty informationLimited warranty Pre-Failure Battery WarrantyRegulatory compliance notices Regulatory compliance identification numbersFederal Communications Commission notice Modifications CablesCanadian notice Avis Canadien European Union regulatory noticeJapanese notice Bsmi notice Battery replacement notice Taiwan battery recycling notice Power cord statement for JapanElectrostatic discharge Preventing electrostatic dischargeGrounding methods to prevent electrostatic discharge Acronyms and abbreviations Communications port, connecting IndexInstallation instructions Repo port, connecting

Related manuals

Manual 61 pages 9.34 Kb