HP R5500 Verifying the Repo port connection Powering down the UPS, Power management software

Verifying the REPO port connection	30
Powering down the UPS	30
Power management	31
Power management software	31
Maintenance	32
Removing the UPS front bezel	32
Removing the ERM front bezel	32
Replacing the UPS electronics module	33
Replacing the UPS option card	34
Replacing the batteries	35
Important battery safety information	35
Battery care and storage guidelines	35
UPS battery replacement procedure	36
Replacing the UPS	37
Replacing the ERM	37
Updating the UPS firmware	38
Troubleshooting	39
LED and audible alarm troubleshooting	39
Battery condition	40
Bypass is out of range	40
General alarm condition	40
Input voltage is out of range	41
Insufficient warning of low batteries	41
Internal UPS fault condition	41
Low battery shutdowns	41
Overload condition	42
REPO condition	42
Site wiring condition	42
UPS does not provide the expected backup time	42
UPS does not start	42
UPS frequently switches between utility and battery power	43
UPS is in Auto-Bypass mode	43
UPS is on battery	43
Utility power condition	43
Specifications	44
UPS physical specifications	44
ERM physical specifications	44
UPS input specifications	44
UPS output specifications	44
Power protection specifications	45
Voltage specifications	45
Output tolerance specifications	46
Output feature specifications	46
Battery specifications	46
Battery runtime for NA/JPN model	46
Battery runtime for INTL model	46
Environmental specifications	47
REPO port specifications	47
Spares	48
Ordering spares	48
Contents	4