HP J4373A, A6584A, A1354A, A1353A, A1356A, J4370A Reconfiguring the agent on HP-UX operating systems

3.From the directory that contains all five files, run ./SetupRA -s-f DevManRA.ini to install silently.

If the .ini file is not located in the same folder as the SetuprRA file, run ./SetupRA -s-f <path> DevManRA.ini, where <path> is the DevManRA.ini file location.

The following command line parameters can be specified and are applicable for both interactive and silent modes.

Parameter	Function
-s	Performs a silent install.
-l	Creates an installation log
	(opt/DevMan/install.log). Default is disabled for
	interactive mode and enabled for silent mode. The
	installation log is created automatically for
	Windows® during silent installations in
	\%systemdrive%\setup.log.
-f DevManRA.ini	Specifies a configuration .ini file used for clean
	installs. When this option is specified, the device
	detection and configuration step is omitted.

Reconfiguring the agent on HP-UX operating systems

To reconfigure the management module IP address or serial path, run /sbin/init.d/DevMan setup.

Uninstalling components from Windows® systems

1.Click Start>Settings>Control Panel.

2.Open Add/Remove Programs.

3.Select UPS Power Protection Agent, and then click Change/Remove. The uninstall wizard launches.

Select Remove Choice, and then click Next.

4.Follow the prompts in the uninstall wizard to uninstall the software.

NOTE: Some files might remain following the uninstallation and can be removed manually.

Uninstalling components from Linux systems

Execute the uninstall script (./Uninstall).

NOTE: Some files might remain following the uninstallation and can be removed manually.

Uninstalling components from HP-UX systems

Execute the uninstall script (./Uninstall).

Installing the HP UPS Power Protection Agent 39