Toshiba RAV-SM2802DT-E, RAV-SM2242DT-TR, RAV-SM2802DT-TR service manual Setup data, Indoor formation

No.	Item		Outline of specifications							Remarks
3	Room temp.	1)	Adjustment range: Remote controller setup temperature (°C)
	control
				COOL		HEAT		AUTO
			Wired type	18 to 29		18 to 29		18 to 29
		2)	Using the Item code 06, the setup temperature in heating Shift of suction
			operation can be corrected.							temperature in heating
										operation
			Setup data		0	2	4		6
			Setup temp. correction		+0°C	+2°C	+4°C		+6°C
			Setup air volume operation
			Indoor formation				Setup data
			1-way Air Discharge Cassette Type
			2-way Air Discharge Cassette Type				2
			Concealed Duct Standard Type
			High Wall Type
			Under Ceiling Type
			Floor Standing Concealed Type				0
			Floor Standing Type
4	Automatic	1)	Based on the difference between Ta and Ts, the operation
	capacity control		frequency is instructed to the outdoor unit.
	(GA control)	2)	Cooling operation
			Every 90 seconds, the room temperature difference
			between temperature detected by Ta and Ts and the varied
			room temperature value are calculated to obtain the
			correction value of the frequency command and then the
			present frequency command is corrected.
			Ta (n) – Ts (n) : Room temp. difference
			n	: Counts of detection
			Ta (n-1) – Ts (n)	: Varied room temp. value
			n – 1	: Counts of detection of 90 seconds before
		3)	Heating operation
			Every 1 minute (60 sec.), the room temperature
			difference between temperature detected by Ta and Ts
			and the varied room temperature value are calculated to
			obtain the correction value of the frequency command
			and then the present frequency command is corrected.
			Ts (n) – Ta (n)	: Room temp. difference
			n	: Counts of detection
			Ta (n) – Ta (n – 1): Varied room temp. value
			n – 1	: Counts of detection of 1 minute before

NOTE)

In case that Low volume is set, the maximum frequency is restricted to approx. [SB].

– 24 –