Toshiba RAV-SM2242DT-TR External view of P.C. board assembly, Address setup, Push Test button

6. External view of P.C. board assembly

Terminator (SW01)

52

85

7.Address setup

In addition to set up the central control address, it is necessary to change the indoor unit number. (Line/Indoor/Group address). For details, refer to 1:1 model connection interface Installation Manual.

9-3. How to Set up Central Control Address Number

When connecting the indoor unit to the central control remote controller using 1:1 model connection interface, it is necessary to set up the central control address number.

•The central control address number is displayed as the line No. of the central control remote controller. <Procedure> Perform setup while the unit stops.

1

2

3

Push TEST + VENT buttons for 4 seconds or more.

When group control is executed, first the unit No. is displayed and all the indoor units in the group control are selected. In this time, fans of all the selected indoor units are turned on. (Fig. 1)

(Keep displayed status without pushing UNIT LOUVER button.)

In case of individual remote controller which is not group-controlled, Line address and Indoor unit address are displayed.

Using temperature setup TEMP. buttons, specify CODE No. ￿!.

Using timer time TIME buttons, select the setup data.

The setup data is shown in the table below (Table 1).

4 Push SET button. (OK if display goes on.)

• To change the item to be set up, return to Procedure 2.

5 Push TEST button.

The status returns to usual stop status.

	(Table 1)
Setup data	Central control address No.
		2
0001	1
0002	2
		1
0003	3
:	:
0064	64
		5
0099	Unset (Setup at shipment from factory)

(Fig.1)

	TEMP			ON / OFF
		TIMER SET	FAN	MODE
			SAVE	VENT
FILTER
RESET TEST		SET CL	SWING/FIX	UNIT LOUVER

3

1

4

– 64 –