Toshiba RAV-SM2802DT-E, RAV-SM2242DT-TR, RAV-SM2802DT-TR service manual Operation section

Concealed Duct High Static Pressure Owner’s Manual

Concealed Duct High Static Pressure Owner’s Manual

nOperation section

Push each button to select a desired operation.

•The control saves commands in memory and after the initial setting, there is no need for any additional settings unless

changes are desired. The air conditioner can be operated by pushing thebutton.

3 4

	1
5	2
	6
7

8

12 11 10

9

13

15

14

1

2

3

4

5 6

7

8

9 10

11

12

– 75 –

11 UNIT No. display

Displays the number of the indoor unit selected.

Also displays error code of indoor and outdoor units.

12 Central control display

Displayed when the air conditioner is used under the central control in combination with a central control remote controller.

In case the remote controller is disabled by the

central control system, flashes. The button operation is not accepted.

Even when you push ON/OFF, MODE, or TEMP. button, and the button operation is not accepted.

(Settings made by the remote controller vary with the central control mode.

For details, refer to the Owner’s Manual of the central control remote controller.)

13 Remote controller sensor display

Displayed while the sensor of the remote controller is used.

14 Pre-heat display

Displayed when the heating mode is energized or defrost cycle is initiated.

While this icon is displayed, the indoor fan stops.

15 No function display

Displayed when the function requested is not available on that model.

1 button (Temperature set button)

Adjusts the set point.

Select the desired set point by pushing

TEMP. or TEMP. .

2 button (Timer set button)

Use to setup the timer.

3 button (Filter reset button)

Resets “ ” icon after cleaning filter.

4 button (Test button)

Use only for service.

(During normal operation, do not use this button.)

5 button

When the button is pushed, the operation starts, and it stops by pushing the button again.

When the operation has stopped, the operation lamp and all the displays disappear.

6Operation lamp

Green light illuminates when unit is on.

Although it flashes when operating the protection device or an error occurs.

7 button (Operation mode button)

Selects desired operation mode.

8 button (Fan speed button)

Fan speed is not adjustable. It is fixed to High.

9 button (Ventilation button)

Use when a power ventilation kit (locally procured) is connected.

•If “ ” is displayed on the remote controller when this button is pushed no vent kit connected.

10 button (Power save operation)

Use to initiate power saving mode.

11 button (Unit/Louver select button)

Selects a unit number (left) and louver number (right).

UNIT:

Selects an indoor unit when multiple indoor units are controlled with one remote controller.

LOUVER:

No Function.

12 button (Swing/Louver direction button)

No Function.

OPTION :

Remote controller sensor

Usually the temperature sensor of the indoor unit senses the temperature.

The temperature on the surrounding of the remote controller can also be sensed.

For details, contact the dealer from which you have purchased the air conditioner.

– 9 – – 10 –