HP 402 G1 manual Solving internet access problems, Set to Enabled in Security USB Security

Page 94

A USB device, headphone, or microphone is not recognized by the computer.

Cause

Solution

 

 

The device does not have power.

If the USB device requires AC power, be sure one end is connected

 

to the device and one end is connected to a live outlet.

 

 

 

The correct device driver is not installed.

1.

Install the correct driver for the device.

 

2.

You might need to reboot the computer.

 

 

 

The cable from the device to the computer does not work.

1.

If possible, replace the cable.

 

2.

Restart the computer.

 

 

 

The device is not working.

1.

Replace the device.

 

2.

Restart the computer.

 

 

USB ports on the computer are disabled in Computer Setup.

Run the Computer Setup utility and ensure that the USB ports are

 

set to Enabled in Security > USB Security.

 

 

 

Solving internet access problems

If you encounter Internet access problems, consult your Internet Service Provider (ISP) or refer to the common causes and solutions listed in the following table.

Unable to connect to the Internet.

Cause

Solution

 

 

Internet Service Provider (ISP) account is not set up properly.

Verify Internet settings or contact your ISP for assistance.

 

 

Web browser is not set up properly.

Verify that the Web browser is installed and set up to work with

 

your ISP.

 

 

Cable/DSL modem is not plugged in.

Plug in cable/DSL modem. You should see a “power” LED light on

 

the front of the cable/DSL modem.

 

 

Cable/DSL service is not available or has been interrupted due to

Try connecting to the Internet at a later time or contact your ISP.

bad weather.

(If the cable/DSL service is connected, the “cable” LED light on the

 

front of the cable/DSL modem will be on.)

 

 

The CAT5 UTP cable is disconnected.

Connect the CAT5 UTP cable between the cable modem and the

 

computers’s RJ-45 connector. (If the connection is good, the “PC”

 

LED light on the front of the cable/DSL modem will be on.)

 

 

IP address is not configured properly.

Contact your ISP for the correct IP address.

 

 

Cookies are corrupted. (A “cookie” is a small piece of information

Windows 8:

that a Web server can store temporarily with the Web browser.

1.

From the Start screen, type c, and then select Control Panel

This is useful for having the browser remember some specific

 

from the list of applications..

information that the Web server can later retrieve.)

 

 

 

 

2.

Click Internet Options.

 

3.

In the Browsing history section on the General tab, click the

 

 

Delete button.

 

4.

Select the Cookies check box and click the Delete button.

 

 

 

86 Chapter 7 Troubleshooting without diagnostics

Image 94
Contents Maintenance & Service Guide Product notice Safety warning notice IiiIv Safety warning notice Table of contents Troubleshooting without diagnostics System board callouts104 100103 Vii110 106107 ViiiDrive configuration may vary by model Product featuresStandard configuration features Standard configuration featuresRear panel components Product featuresSerial number location Activating and customizing the software in Windows Downloading Windows 8 updatesActivating and customizing the software Activating the Windows operating systemMajor components Illustrated parts catalogIllustrated parts catalog Miscellaneous parts Item Component Access panelFront bezel Fan sink Power supply, 250 W Processors Miscellaneous partsTB, 7200 rpm, 3.5 inch 500-GB, 7200 rpm, 3.5 inch Mass storage devicesHard drives Optical driveSata hard drive cables Serial ATA Hard Drive CharacteristicsSata hard drives Sata data cableGenerating static Smart ATA drivesElectrostatic discharge information Preventing electrostatic damage to equipmentStatic Shielding Protection Levels Personal grounding methods and equipmentGrounding the work area Method VoltageOperating guidelines Recommended materials and equipmentCleaning the keyboard General cleaning safety precautionsCleaning the computer case Routine careCleaning the mouse Service considerationsCleaning the display Tools and software requirementsLithium coin cell battery Cables and connectorsHard drives Removal and replacement procedures Preparing to disassemble the computerAccess panel Removing a slim optical disc drive Installing and removing drivesDescription Page Page Installing a slim optical disc drive Page Remove the access panel see Access panel on Removing and replacing a 3.5-inch hard drivePage Page Page Front bezel To remove the front bezelPage Memory Remove the access panel see Access panel on MemoryGB memory module PC3-12800 4GB memory module PC3-12800 Page Expansion cards Page Fan Page RTC battery RTC batteryFan sink Page Processor Before removing the processor, follow these stepsPage Power supply Page System board To remove the system boardUpdating Smbios Information System boardSystem ID Setup Setup Field Name Comment LabelSystem board callouts Sys Bd Label ComponentNetwork connector and USB Front I/O USB connectorRTC battery VGA connectorComputer Setup F10 Utility Computer Setup F10 UtilitiesComputer Setup F10 Utility Using Computer Setup F10 Utilities1Computer Setup F10 Utility Computer Setup-File 2Computer Setup-FileComputer Setup-Storage 3Computer Setup-StorageComputer Setup-Security 4Computer Setup-SecurityDevice Security Network BootMaster Boot Record USB SecuritySystem Security System Security theseDriveLock Security Configuration Secure BootLegacy Support to disabled Computer Setup-Power 5Computer Setup-PowerComputer Setup-Advanced 6Computer Setup-Advanced for advanced usersBus Options PCI SERR# Generation. Default is enabledVGA Configuration AMT Configuration Device OptionsRecovering the configuration settings Troubleshooting without diagnostics Safety and comfort Before you call for technical supportHelpful hints 1Solving General Problems Solving general problemsSolving general problems Computer date and time display is incorrect Cause SolutionCannot remove computer cover or access panel Cause Solution Cause SolutionThere is no sound or sound volume is too low Cause Solution Poor performance Cause SolutionUnder Windows System, click Run Solution 2Solving Power Problems Solving power problemsSolving power problems Power supply shuts down intermittently Cause SolutionSolving hard drive problems 3Solving Hard Drive ProblemsSolving hard drive problems Can not write to the media card Cause Solving media card reader problems4Solving Media Card Reader Problems Computer’s software is used to safely eject the card5Solving Display Problems Solving display problemsSolving display problems Blank screen no video Cause SolutionScreen resolution Dim characters Cause Solution Image is not centered Cause SolutionOut of Range displays on screen Cause No Connection, Check Signal Cable displays on screen CauseSelect the monitor’s Auto-Adjustment option Monitor’s on-screen display menuSolving audio problems Solving audio problems6Solving Audio Problems Select Device Manager Sound from headphones is not clear or muffled CauseThere is no sound or sound volume is too low Cause Line-in jack is not functioning properly CauseSolving printer problems Solving printer problems7Solving Printer Problems Solving keyboard and mouse problems 8Solving Keyboard ProblemsShut down the computer using the keyboard Solving hardware installation problems9Solving Mouse Problems Components10Solving Hardware Installation Problems Computer will not start Cause Solution11Solving Network Problems Solving network problemsSolving network problems Power SavingsNetwork status link light never flashes Cause Solution Wake-on-LAN feature is not functioning Cause SolutionAdvanced Device Options S5 Wake on LAN Settings for the board Correct operating modeDiagnostics reports a failure Cause Solution Cable CorrectlyNew network card will not boot Cause Solution Solving memory problems Solving memory problems12Solving Memory Problems Some fans only operate when needed Solving processor problems13Solving Processor Problems Make sure the processor heat sink is installed properly14Solving CD-ROM and DVD Problems Solving CD-ROM and DVD problemsSolving CD-ROM and DVD problems Computer Setup utilityMovie will not play in the DVD drive Cause Solution Cannot eject compact disc tray-load unit CauseSolving USB flash drive problems Solving USB flash drive problemsSolving front panel component problems 15Solving USB Flash Drive ProblemsUnable to connect to the Internet Cause Solution Solving internet access problemsSet to Enabled in Security USB Security Click Internet OptionsSolving software problems Solving software problemsContacting customer support Why run HP PC Hardware Diagnostics Uefi HP PC Hardware DiagnosticsHow to access and run HP PC Hardware Diagnostics Uefi Diagnostic section, click HP Uefi Support Environment Backup and recovery in Windows Backup and RecoveryBacking up your information To recover information you previously backed up Performing a system recoveryFollow the on-screen instructions Backup and Recovery Using f11 recovery tools Post Numeric Codes and Text Messages Post Error MessagesPost Error Messages 1Numeric Codes and Text MessagesPost Numeric Codes and Text Messages Reconfigure card resources and/or run Flash Screen Image Corrupted Flash Screen image has errorsReseat power supply fan Computer Setup or Windows utilitiesEmulation to IDE, and select File Save Inventory error during MEBx execution Try a different USB key device forGeneral error during MEBx execution Functionality contained in the system BiosSystem Bios version System Bios and ME firmwarePossible Cause Recommended Action White Power LED On Interpreting Post diagnostic front panel LEDs2Diagnostic front panel LEDs and audible codes ActivityInterpreting Post diagnostic front panel LEDs Possible Cause Recommended ActionInstall a TXT capable processor Red Power LED flashes sevenRecovery Mode section of the Desktop Previously enabled on thisEstablishing a Setup or Power-on password Password Security and Resetting CmosEstablishing a Setup or Power-on password Clearing and resetting the Cmos Resetting the Setup and Power-on passwordPassword Security and Resetting Cmos Page Japanese Power Cord Requirements Power Cord Set RequirementsGeneral requirements Country-specific requirements Country-specific requirementsCountry Accrediting Agency Statement of Volatility Appendix B Statement of VolatilityEnter the F10 setup utility Specifications SpecificationsAppendix C Specifications Index Network Setup password 103 Power Software Printer Problems All-in One chassis Fan Password Fan sink103 Problems Product ID location Removal and replacement
Related manuals
Manual 34 pages 13.56 Kb