The following table describes the LEDs on the card panels.
Table 20 LED description 2-port ADSL FIC
OFF means that the line is inactive, ON means that the line has been activated and has entered the data mode, and blinking means that the line is being
LINK activated.
OFF means no data is being transceived on the interface and blinking means data
ACT is being transceived.
Interface Cable
The standard equipping package of
Interface Cable In G. Lite mode, no splitter is required. You can directly connect one end of the telephone cable to the Router and the other end to the PSTN, and simply connect the
In full rate mode, a splitter is required. Follow these steps to connect the cables:
1Plug one end of a telephone cable into the ADSL port on the Router, and the other end into the inbound ADSL port on the splitter.
2Connect the telephone to the phone port on the splitter with another telephone cable.
3Connect the outbound ADSL port on the splitter to the PSTN with a third telephone cable.
Figure 20 Connect 2-port ADSL FIC
Router | RJ11 port |
|
D
S
Phone portL A
ADSL card
Splitter
Modem port
PSTNM
Lineport