HP 6000 Router manual Troubleshooting Power System, Configuration System

6

TROUBLESHOOTING

Troubleshooting

Power System

Fault: POWER RUN LED is OFF or blinks.

Please check:

■If the power switch of the Router is turned on.

■If the power supply switch is turned on.

■If the power cord of the Router is properly connected.

■If the power supply meets the requirement of the Router. Steady on means the input voltage is normal (85-264V), off means the input voltage is abnormal.

Troubleshooting	After the Power-On Self-Test (POST) of the Router, if the system operates normally,
Configuration System	the start-up information should be displayed on the console terminal. If the
	configuration system has some fault, the terminal may display nothing or only
	illegible characters.
Fault: “nothing being	After the Power-On Self-Test (POST) of the Router, if the terminal does not display
displayed on the	any information.
terminal”	Please check:
	■ If the power system is normal.
	■ If the console cable is connected correctly.
	If there's nothing wrong after all the items above have been checked, it is likely
	that there is something wrong with the console cable or the terminal (e.g., the
	HyperTerminal) parameters. Please check the cable or the parameters.
Fault: “displaying	After the Power-On Self-Test (POST) of the Router, if the console terminal displays
illegible characters on	illegible characters.
the terminal”	Please check the following:
	■	Baud: 9600
	■	Data bits: 8
	■	Stop bit: 1
	■	Parity: None
	■	Flow control: None