HP J4660 Set up backup fax, To set backup fax from the device control panel, On Error Only, Off

4.If you are currently on the phone with the sender, instruct the sender to press Start on their fax machine.

5.When you hear fax tones from a sending fax machine, do the following:

a. Press the left arrow or the right arrow to select Fax B&W or Color fax. b. Press Start.

c. After the device begins to receive the fax, you can hang up the phone or remain on the line. The phone line is silent during fax transmission.

Set up backup fax

Depending on your preference and security requirements, you can set up the device to store all the faxes it receives, only the faxes it receives while the device is in an error condition, or none of the faxes it receives.

The following Backup fax modes are available:

On	The default setting. When Backup fax is On, the device stores all
	received faxes in memory. This enables you to reprint up to eight of the
	most recently printed faxes if they are still saved in memory.
	NOTE: When device memory is low, it overwrites the oldest, printed
	faxes as it receives new faxes. If the memory becomes full of unprinted
	faxes, the device stops answering incoming fax calls.
	NOTE: If you receive a fax that is too large, such as a very detailed
	color photo, it might not be stored in memory due to memory limitations.
On Error Only	Causes the device to store faxes in memory only if an error condition
	exists that prevents the device from printing the faxes (for example, if the
	device runs out of paper). The device continues to store incoming faxes
	as long as there is memory available. (If the memory becomes full, the
	device stops answering incoming fax calls.) When the error condition is
	resolved, the faxes stored in memory print automatically, and then they
	are deleted from memory.
Off	Faxes are never stored in memory. For example, you might want to turn
	off Backup fax for security purposes. If an error condition occurs that
	prevents the device from printing (for example, the device runs out of
	paper), the device stops answering incoming fax calls.

NOTE: If Backup fax is enabled and you turn off the device, all faxes stored in memory are deleted, including any unprinted faxes that you might have received while the device was in an error condition. You must contact the senders to ask them to resend any unprinted faxes. For a list of the faxes you have received, print the Fax Log. The Fax Log is not deleted when the device is turned off.

To set backup fax from the device control panel

1.Press Setup.

2.Press right arrow until Tools appears, and then press OK.

3.Press right arrow until Backup fax appears, and then press OK.

4.Press right arrow to select On, On Error Only, or Off.

5.Press OK.

Receive a fax 49