INSTALLATION CONFIGURATIONS
Note: Where passage through a wall, or partition of combustible construction is desired, the installation shall conform to CAN/CSA
The American Harvest Corn/Pellet Stove Model 6035 may be installed as follows:
1)A freestanding unit
2)A
MOBILE HOME INSTALLATION REQUIREMENTS
IN ADDITION TO THE STANDARD INSTALLATION INSTRUCTION, THE FOLLOWING
REQUIREMENTS ARE MANDATORY FOR INSTALLATION IN A MOBILE HOME:
WARNING
DO NOT INSTALL IN SLEEPING ROOM
1)Stove must be permanently bolted to the floor.
2)Stove must have permanent outside air source. (60FAK)
3)Stove must be permanently electrically ground to the steel chassis of the mobile home.
4)All vertical chimney vent must have wall supports every (5) five feet.
5)All exhaust systems must have a spark arrestor.
CAUTION
THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL AND CEILING/
ROOF MUST BE MAINTAINED.
Check with your local building official as other codes may apply.
PEDESTAL
BOLT
FLOOR
STEEL CHASSIS
ELECTRICALLY
GROUNDED TO CHASSIS
USSC | 9 |