Teka FSFF90GGS/S 40297240 guide

WARNING: For the model with single grill burner, the grill burner always operates at maximum and therefore no minimum adjustment is required.

NOTE: The above-mentioned adjustment should be made only with natural gas burners, while for those operating with liquid gas the screw must be locked at the end in a clockwise direction. The grill burner always operates at maximum, therefore no minimum adjustment is required.

CONNECTING THE APPLIANCE TO THE ELECTRIC POWER SUPPLY

Connection to the electric power supply must conform to laws and regulations in force.

Before making the connection make sure:

•The electric wiring and sockets are suitable for the maximum rating of the appliance (see the serial no. plate on the lower part of the cooker body).

•The socket or wiring is effectively earthed in accordance with laws and regulations in force. The manufacturer shall not be held liable for failure to observe these provisions.

When the appliance is connected to the electric power supply by a socket:

•Make sure the lead has a normalised plug suitable for the rating indicated on the serial no. plate. Connect the wires according to the diagram in FIGURE 15, observing the following:

letter L (live) = brown wire; letter N (neutral) = blue wire; symbol (earth) = green-yellow wire;

•The lead must be positioned so no part of it exceeds a temperature of 75 K.

•Do not use reductions, adaptors or shunts for the connection, as these could generate false contacts and cause hazardous over-heating.

When the appliance in connected directly to the electric power supply:

•Make sure there is a device to disconnect the appliance from the mains, with a contact opening distance sufficient for complete disconnection in category III excess voltage conditions.

•The earthing wire must not be interrupted by the switch.

•Alternatively, a high-sensitivity residual current device can be used to protect the electrical connection.

We strongly recommend securing the green-yellow earthing wire to an efficient earthing system.

WARNING: If the power lead is replaced, the earthing wire (yellow-green) connected to the terminal board should be 2 cm longer than the other wires.

CARING FOR YOUR APPLIANCE

NOTE: IMPORTANT INFORMATION

For cookers resting on a base

NOTE: If the appliance rests on a base, take precautions to prevent the appliance sliding off the base.

For cookers with an electric oven

The appliance heats up during use. Do not touch the heating elements inside the oven.

For cookers with an electric oven

NOTE: Accessible parts may heat up during use. Keep children away from the cooker.

For glass oven doors

Do not use abrasive cleaning products or metal spatulas with sharp edges to clean the glass oven door, as this could scratch the surface and the glass could break.

Do not use steam cleaners to clean the appliance

NOTE: various parts of the cooker heat up reaching temperatures which seem very high but which are actually fully within safety limits. According to these limits:

1)With the oven on at 200°C for 1 hour, front accessible parts which cannot be grasped, can reach the following temperatures:

-Control panel: Tmax = Room Temperature +60°C

-Glass of the oven door: Tmax = Room temperature+60°C

-Metal part of the oven door: Tmax = Room temperature+45°C

2)With the oven on at 230°C for 1 hour, the parts which can be grasped, can reach the following temperatures:

-Plastic knobs: Tmax = Room temperature+60°C

-Metal oven door handle: Tmax = Room temperature+35°C

where the room temperature is the temperature in °C of the place where the appliance is installed.