Pelco es3012 installation manual Az/El

AZ/EL

MAIN MENU

<Limit Stop>

<Other>

EXIT

Other Menu

Park Time	0
Pan/Scan Spd	7
Power Up	Default
Pat length	6 min

Spd Profile 50 MPH wind

<Zone Blank>

<Az/El/Direction>

Exit

Az/El/Direction

Set Azimuth Zero

Az/El

Az/El Line

Direction

Direction Line

Disp Duration

Exit

NOTE: Az/El display is not available while you are programming or running a pattern.

Az/El programs the horizontal display position of the Azimuth1/Elevation2 label.

The following settings are available for the Az/El label:

Off – Label is not displayed.

Left (default) – Label is displayed on the left-hand side of the screen. Center – Label is displayed in the center of the screen.

Right – Label is displayed on the right-hand side of the screen.

To program the horizontal label position for Az/El:

1.Program preset 95 (28). The main menu appears.

2.Position the cursor (>) beside Other.

3.Press the Iris Open button to enter the Other menu.

4.Position the cursor (>) beside Az/El/Direction.

5.Press the Iris Open button to enter the Az/El/Direction menu.

6.Position the cursor (>) beside Az/El.

7.Press the Iris Open button. The cursor moves to the right.

8.Move the joystick up or down to view the available selections.

9.SELECT – Press the Iris Open button to make a selection. CANCEL – Press the Iris Close button to cancel selection.

1Azimuth is the pan angle from 0° to 359°.

2Elevation is the tilt position from 33° to -83°.

18 Pelco Manual C306M-K (4/05)