Pelco es3012 installation manual AZ/EL Line

Page 19

AZ/EL LINE

MAIN MENU

<Limit Stop>

<Other>

EXIT

Other Menu

Park Time

0

Pan/Scan Spd

7

Power Up

Default

Pat length

6 min

Spd Profile 50 MPH wind

<Zone Blank>

<Az/El/Direction>

Exit

Az/El/Direction

Set Azimuth Zero Az/El

Az/El Line

Direction

Direction Line

Disp Duration

Exit

NOTE: Az/El display is not available while you are programming or running a pattern.

Az/El Line controls the vertical display position of the Azimuth/Elevation label. The label may be displayed on lines 3 through 10. Line 3 is the third line from the top of the screen and line 10 is located at the bottom of the screen. Line 10 is the default setting.

To program the vertical label position for Az/El:

1.Program preset 95 (28). The main menu appears.

2.Position the cursor (>) beside Other.

3.Press the Iris Open button to enter the Other menu.

4.Position the cursor (>) beside Az/El/Direction.

5.Press the Iris Open button to enter the Az/El/Direction menu.

6.Position the cursor (>) beside Az/El Line.

7.Press the Iris Open button. The cursor moves to the right.

8.Move the joystick up or down to view the available selections.

9.SELECT – Press the Iris Open button to make a selection. CANCEL – Press the Iris Close button to cancel a selection.

Pelco Manual C306M-K (4/05)

19

Image 19
Contents ES3012 Series Esprit Pelco Manual C306M-K 4/05 Contents List of Illustrations Esprit ES3012 System Dimensions DrawingList of Tables Important Safety Instructions Models DescriptionBasic Camera and Lens Installation InstallationPIN Holder PAN and Tilt Installation RX+ Pelco Manual C306M-K 4/05 HOW to Remove the PAN and Tilt Cover TXB Series Translator Board Installation OptionalHOW to Reinstall the PAN and Tilt Cover Operating Notes Environmental Range POWER-UP DisplayHOW to Operate Your Esprit Integrated Positioning System OperationRANDOM, FRAME, and Auto Scanning Preset FunctionsPAN, SCAN, and Tilt Speeds Lens FunctionsProgramming PresetsEsprit Menus Accessing Main Menu Preset AZ/EL AZ/EL Line Azimuth Zero Direction Direction Line Display Duration Programming Limit Stops Limit Stops Turning Limit Stops on or OFFScan Limit Stops Park Time PAN/SCAN SpeedPattern Length POWER-UP Mode Speed Profile Other Menu Zone BlankSymptom No control RS-422 TroubleshootingSymptom System does not operate Symptom No control/sluggish control CoaxitronSymptom No video or poor video MaintenanceAppendix Switch Setting SW1-4 SW1-5Baud Rate Table B. Switch Settings for SW2 112 232 Electrical SpecificationsALL Others are Inches Regulatory Notices Product Warranty and Return Information ISO9001