Stovax 8547LUC-P8547LUC manual Lighting, Never Operate the Stove When the Door is Removed

INSTALLATION INSTRUCTIONS

INSTALLATION

5.4Place the second ash panel to the right of the first, with the pointed end of the panel fitting into the V shape. This panel should locate on the screw holes of the burner skin. Ensure that both logs are horizontal to the burner ports.

14

AR1615

5.5Place log E across from the rear of log A to log C on the right hand side. Again, there are cut-outs for location. The front of the log should sit on the front ash panels and should fit tight to log C. See diagram 15.

15

AR1616

5.6Carefully insert the front coal retainer into the front panel of the firebox. Take care not the scrape/damage the logs. This coal retainer sits in two brackets. Ensure it is fully inserted, leaving approximately a 4 mm gap between the firebox ledge and the bottom of the coal retainer.

16

5.7Ensure that the fibreglass seal on the back of the door is intact, locate the door on the four studs and slide back to the firebox. Secure in place using the four dome nuts and tool supplied, do not overtigthen the nuts, see diagram 17.

17

AR0540

NEVER OPERATE THE STOVE WHEN THE DOOR IS REMOVED.

6.LIGHTING

6.1Full instructions are given in the User section under Lighting the Stove.

AR1617

18