Stovax 8545LUC, P8545LUC, 8547LUC-P8547LUC manual Site Requirements, Flue and Chimney Requirements

Page 9

INSTALLATION INSTRUCTIONS

SITE REQUIREMENTS

1. FLUE AND CHIMNEY REQUIREMENTS

NOTE: This appliance can only be installed in conjunction with the flue supplied.

1.1The flue must be sited in accordance with BS5440: Part 1 (latest editon). See diagram 1.

1.2Any terminal which is less than 2 metres above any access (level ground, balcony or above a flat roof to which people have access), is to be fitted with the guard.

1.3All vertical and horizontal flues must be securely fixed and fire precautions followed in accordance with local and national codes of practice.

1.4A restrictor may be required. Refer to Technical Specifications on previous page.

1.1 TIMBER FRAMED BUILDINGS

1.5It will be necessary to provide additional clearance when the fire passes through a wall containing any combustible materials so as to prevent a fire hazard.

1.6The hole through which the flue will pass, must have a steel sleeve which is positioned so that an air gap of at least 25mm is maintained between the outer surface of the flue, and any part of the sleeve.

1.7For further guidance on the installation of gas appliances in timber framed buildings, contact your local buildings control authority.

NOTE: ATTENTION MUST BE GIVEN TO ALLOWING ADEQUATE CLEARANCE AT THE SIDES AND REAR OF THE STOVE, TO PROVIDE ACCESS FOR SERVICING.

1

AR0602

9

Image 9
Contents Clarendon & Ashdon Log Effect Stove Range Contents Appliance Commissioning Checklist Flue Check Pass FailGAS Check General User InstructionsLighting the Stove Turning OFF the StoveCleaning the Fire Handling & Disposal of Fire CeramicsFuel BED Arrangements Never Operate the Stove When the Door is Removed Flame Failure Device Installation Details‘RUNNING IN’ ServicingTechnical Specification Installation InstructionsSite Requirements Flue and Chimney RequirementsTimber Framed Buildings TOP Exit Rear FlueTOP Flue UP & OUT with Additional Bend ALL AppliancesOptional Extra Flue Lengths & Bends Ventilation Installation of the GAS SupplyAppliance Location Minimum ClearanceControl Upgrade InstallationSafety Precautions Installation of the StoveDo not FIX the Flue AT this Stage Do not Attempt to Shorten ANY Other Section of Flue Pipe Vertical & Horizontal FlueTOP Exit Vertical Flue Table a TOP Exit Vertical only Including OffsetRemove ANY Cardboard Fitment Remaining Fuelbed Arrangements Lighting Commissioning CommissioningServicing Instructions Servicing / Fault Finding ChartsServicing Requirements Ignition Functional CheckPilot will not Stay LIT or Fire Goes OUT in USE Flame Failure Functional CheckReplacing Parts Main BurnerPilot Unit Ignition Lead Piezo Magnetic Safety ValveGAS Valve Main InjectorPrimary Aeration Plate Changing Between GAS TypesShort Spares List Service Records Member of the Stovax Group