Stovax 8545LUC, P8545LUC Primary Aeration Plate, Changing Between GAS Types, Short Spares List

SERVICING INSTRUCTIONS

REPLACING PARTS

8.4Holding the injector with a spanner, undo the feed pipe.

NOTE: THE ORIENTATION OF THE INJECTOR.

8.5Reassemble in reverse order, turn on the gas supply and check for any leaks.

9.PRIMARY AERATION PLATE

9.1Turn the gas supply off at the isolation device.

9.2Refer to section 2 to remove the main burner.

9.3Remove the two screws on the burner skin to detach the venturi cover from the venturi. Slide the venturi cover off the venturi as per diagram 13.

13

AR1608

9.4Refer to the technical specification and databadge to check the gas type and its required aeration plate. Change the aeration plate, if necessary.

14

AR0619

9.5Reassemble in reverse order with correct aeration plate(s).

Note: Even if no aeration plate is required, the small screw(s) must be replaced.

10. CHANGING BETWEEN GAS TYPES

In order to change between gas types, it will be necessary to change the following items:

-Pilot Injector

-Control Valve

-Main Injector

-Main Burner

-Aeration Plate

-Databadge

The relevant parts can be ordered from the parts list, always quote the appliance type and serial number when ordering spare parts.

NOTE: THE CONTROL VALVE IS FACTORY PRESET FOR THE CORRECT GAS TYPE AND MODEL, A NEW UNIT WILL NEED TO BE ORDERED WHEN CHANGING BETWEEN GAS TYPES.

11. CONTROL UPGRADE

See section 4 in User Instructions.

12. SHORT SPARES LIST

Short spares list Bal flue

Component	NG	LPG
	G20	G30	G31
	20mb	29mb	37mb
Main Injector	IN0045	IN0030	IN0030
Aeration plate	N/A	N/A	ME1350
Pilot injector	PI0026	PI0015
Burner assembly	GZ5369	GZ5388
Thermocouple		PI0011
Magnetic unit		GC0092
Electrode		PI0053
Pilot Gasket		PI0052
Gas valve		GC0088K
Ignition lead		GC0090
Complete log set		CEO583
Log A		CEO584
Log B		CEO585
Log C		CEO586
Log D		CEO587
Log E		CEO588
Left ash panel		CEO589
Right ash panel		CEO590
Standard upgrade kit		8455
Thermostat/timer kit		8456

25