USER INSTRUCTIONS
1.general
1.1Installation and servicing must only be carried out by a competent person.
1.2In all correspondence, please quote the fire type and serial number, which can be found on the data badge adjacent to the control knob.
1.3Ensure that curtains are not positioned above the fire, and that there is a 300mm minimum clearance between the sides of the fire and any curtains.
1.4This product is guaranteed for 2 years from the date of installation, as set out in the terms and conditions of sale between Gazco and your local Gazco dealer. Please
consult with your local Gazco dealer if you have any questions. In all correspondence always quote the Model Number and Serial Number.
1.5The decorative front and glass become hot during normal use and should be treated as a ‘working surface’. It is therefore recommended that a suitable fire guard be used for protection of young children and the infirm.
1.6If any cracks appear in the glass panel do not use the fire until the panel has been replaced.
2.LIGHTING THE FIRE
2.1Locate the control valve on the fire. There are two control knobs on the valve, the
2.2If your fire has already been upgraded to battery remote control, please refer to the instructions provided with the upgrade to operate the remote control. The following instructions work for either situation.
1
AR0914
•Ensure that the 
).
•Ensure that the 
).
•Press in the
•Keep pressing in and the knob is pointing to pilot ( 
)
The pilot should now light. If the pilot has not lit, repeat the procedure until it does.
•Hold the control knob pressed in 10 seconds and then release it
The pilot should stay alight. If the pilot goes out, repeat the steps.
2.3If the pilot does not light after repeated attempts, contact the retailer or installer from whom the fire was purchased.
2.4Turn the 
). The fire can now be controlled using the
2.5Turn the 
), the main burner now lights on low. The burner can
now be controlled between low and high settings. Turn the control knob anti clockwise to increase the flame height and clockwise to decrease the height.
2.6If the pilot flame is extinguished, intentionally or unintentionally, do not relight the appliance for at least 3 minutes.
3.TURNING THE FIRE OFF
3.1To turn the fire off, locate the control valve, turn the left- hand control knob until it points to off (
). The main burner goes out leaving the pilot burning.
3.2To turn the pilot off, locate the control valve, turn the right- hand control knob until it points to off (
). The pilot will go out.
4.upgrading your fire
4.1Your fire is fitted with a control valve that can easily be upgraded to battery powered remote control. This upgrade can be fitted by anyone capable of simple DIY jobs and requires no special training. This upgrade can be obtained through your local Gazco stockist.
4.2STANDARD REMOTE CONTROL This remote control can control the fire after the pilot has been lit. It can turn the main burner on and regulate it from low through to high and back again. It can turn the main burner off leaving the pilot burning GAZCO PART NUMBER 8455.
4.3PROGRAMMABLE THERMOSTATIC AND TIMER REMOTE CONTROL. This remote control can control the gas fire after the pilot has been lit. In MANUAL MODE it can be used to turn the main burner on and manually regulate it from low through to high and back again. It can be used to turn the main burner off, leaving the pilot burning. In AUTO MODE it will automatically regulate the room temperature to a preset temperature. In TIMER MODE it will turn the fire on and off according to preset programme and automatically regulate the room temperature during the two periods. GAZCO PART NO. 8456.
4