LOREX Technology WA-410 instruction manual Replacement Menu, Clear Menu

listed below. It will automatically advance to the next sequencing learning order position.

Sequential Pgming

Sensor Added

Sequential Pgming

Trigger Sensor 02

7.If the sensor that was learnt into the main console is sending a signal during the learning mode, the main console will indicate on the LCD, as shown below and will not allow duplication.

Sensor Already

Exists in System 02

8.If the sensors “learned” reaches 63 zone numbers, the LCD panel will show a full message memory.

Sequential	Pgming
Mem Full	63

3.3: Replacement Menu

When the sensor becomes faulty and needs to be replaced with a new one you will need to activate the menu. To replace the original sensor, key-in the sequence learning order number and press ENTER . Trigger the sensor, and the new sensor will “learn’ into the main console.

Note: Please use the same type of sensor to replace the old one.

Press 2 to go into the replace sensor mode.

Replace Sensor

Enter Sensor Num :

Trigger Sensor To

Replace 01

Once replaced, It will go back to the system menu as shown below.

SYS_OPTS: 0-SYS_OPTS

1 – SEQ 2 – REPLAC 3 - CLR

3.4: Clear Menu

Clear Sensors ( 1 - Single 2 – All )

Select 1- Single, key-in the sequencing learning order number and press ENTER . It will clear that sensor. If you select 2- All, all learned sensors will

11