LOREX Technology WA-410 instruction manual Door/Window Detector

Page 20

Before installing the sensor, consider the following points:

zMount the sensor two meters (6-1/2’) high for best coverage.

zMount the sensor with a 14 degree downward incline angle against the wall for optimum range.

To install the PIR Motion Sensor, please follow these steps:

zTake out the screws or double sided adhesive and install the mounting bracket on the wall. Press the ball joint portion into the bracket until it snaps securely. (Secure the mounting bracket on the wall, 2 meters above the floor).

zPlace the PIR sensor on the mounting bracket.

zTest the PIR sensor by walking within its range. When the sensor is triggered, the red LED light will flash once for 1 second.

Door/Window Detector

The magnetic Door/Window detector is a contact sensor, and should be applied on a door or window. When the magnetic contact is opened (broken) or the battery is low, the sensor will send out a message to the main console. A message on the triggered sensor can be seen on the Main Console’s LCD display.

19

Image 20

Contents Wireless Home Security System Table of Contents Important Safety Instructions Personalized IntroductionExpandability Planning for Installation Setting Alarm ZonesPowering the Main Console Choosing LocationConnecting the Telephone Line Setting the AntennaAbout Passwords Mounting the Main ConsoleOperation Main Console LCD Panel IllustrationAntenna Used for wireless reception DC Power Jack DC supply inputSpeaker Line JackSystem Option menu Press 0 to start setting Setting Message Rec Sel Msg 1 25 Sec Setting Message Play Sel Msg 1 25 SecSetting Dialer Mode Setting Change Code InstallSequence Programming Menu Replacement Menu Clear MenuFunction for Master Menu Factory Default Password Check Function Speed Dial FunctionArm or Disarm Via the Telephone Line for Tone Mode Auto-dialer priorityResponse message as listed below If system is triggeredHour Mode Gas Detector and Remote Control Handset Panic buttonLCD MSG Message indicating on LCD Away and H-HOME modesRemote Control Handset Zone Address SettingTo Arm or Disarm with the Remote Control Handset Remote Sensor Armed HomePanic Main FeaturesPIR Motion Detector Replace the Battery Installing the PIR Motion SensorLow battery Do not install any PIR motion sensor in the following areasTo install the PIR Motion Sensor, please follow these steps Door/Window DetectorChange the Battery Door/Window Detector for DC 12V batteryInstalling the Door/Window Detector Installing for DC 12V DetectorLCD display on the Main Console for Door/Window Detector TamperMini Siren Summary of Program Main Console Summary of Sensors and Zone Settings DescriptionsSpecifications Learning Place Zone LabelItems Installation TemplateSpecifications Page It’s all on the web