1.The LED on the sensor will flash once when the sensor is triggered.
2.There cannot be a gap greater than 1/4 inch (5 mm) between the magnet sensor and the magnet, otherwise, the sensor will not work properly.
Enter the installer password and press the “1” button to activate the “Sequence Programming Menu”. Take the magnet away from the magnet sensor. It will trigger the sensor and the LED will light for 1 sec. The Main Console will emit one ‘Beep’ and the LCD will display, ‘Sensor Added’. The sensor has programmed into the main console successfully.
LCD display on the Main Console for Door/Window Detector
When the system is in the armed mode. (message shown on main console)
• | Window opened | Door opened |
63 WINDOW SENSOR
01 Open
63 DOOR SENSOR
01 Open
When the system is in the process of arming, and the sensor has been opened prior to the arming. (message shown on main console)
•Window opened
63 WINDOW SENSOR
01 Open
•Window battery cover opened
63 WINDOW SENSOR
01 Tamper
Door battery cover opened
63 DOOR SENSOR
01 Tamper
Installing the Door/Window Detector
Installing for( DC 12V Detector):
To install a Door/Window Detector, follow these steps:
1.Before installing the sensor, ensure the sensor has programmed into the main console successfully
2.Apply double sided adhesive tape to the back of the sensor.
3.Find the arrow embossed on the sensor, just below the LED light. Find a similar arrow on the magnet. Before exposing the adhesive backing, align the two arrows on the surface where you want them installed. Check that both parts of the device fit and that they can be mounted with a gap less than 1/4 inch between them.(refer to the picture below).
4.Reconfirm the setting on the main console, Press the CHECK button, and then open the window. The main console will receive the sensor signal and leave a message on the LCD display for about 2 seconds. Note: Checking this will require two people
21