LOREX Technology WA-410 instruction manual Check Function, Speed Dial Function

Page 14

zIf the password is correct, the main console will emit a long beep sound. (LCD display shown below).

Access Granted

Master Mode :

MASTER

A-AWAY H-HOME

Now the system will select the arm mode and set the system in either Away arm/Home Arm mode (see below):

A - AWAY : Press the AWAY button to set the “ Armed - Away “ alert. After the exit delay the Arm LED will illuminate steady and the system is armed in the AWAY mode.

00 HOME SECURITY

Armed AWAY

H - HOME : Press the HOME button to set “ Armed - Home “ alert. After the exit delay the Arm LED will blink and the system is armed in the AWAY mode.

00 HOME SECURITY

Armed HOME

Check Function

Press the CHECK button to check the programmed data without any password. It can only review, but it can not change the data in the ‘Check’ Mode. The menu structure is listed below.

Check :

0

– T

: To review (1- Exit) Exit time, (2-Alarm) Alarm time, (3- Entry) Entry

 

 

time.

123456 – P

: To review phone number sets.

7

– MSG

: To review recorded message

8

– DIAL

: To review dial mode.

Programmed devices can be checked without the activation of the alarm. When the main console receives data from the device/sensor the LCD displays zone label/status to confirm proper communication between the device/console status.

Speed Dial Function

zPress and hold the SP DIAL button and the assigned button. The Main console will automatically execute the autodial and alarm. If you want to cancel the autodial and alarm when they are activated, key-in the Master password to cancel them or use the Remote Control disarm button.

13

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Wireless Home Security System Table of Contents Important Safety Instructions Personalized IntroductionExpandability Powering the Main Console Planning for InstallationSetting Alarm Zones Choosing LocationAbout Passwords Connecting the Telephone LineSetting the Antenna Mounting the Main ConsoleOperation Main Console LCD Panel IllustrationSpeaker Antenna Used for wireless receptionDC Power Jack DC supply input Line JackSystem Option menu Press 0 to start setting Setting Dialer Mode Setting Message Rec Sel Msg 1 25 SecSetting Message Play Sel Msg 1 25 Sec Setting Change Code InstallSequence Programming Menu Replacement Menu Clear MenuFunction for Master Menu Factory Default Password Check Function Speed Dial FunctionResponse message as listed below Arm or Disarm Via the Telephone Line for Tone ModeAuto-dialer priority If system is triggeredLCD MSG Message indicating on LCD Hour ModeGas Detector and Remote Control Handset Panic button Away and H-HOME modesTo Arm or Disarm with the Remote Control Handset Remote Control HandsetZone Address Setting Remote Sensor Armed HomePanic Main FeaturesPIR Motion Detector Low battery Replace the BatteryInstalling the PIR Motion Sensor Do not install any PIR motion sensor in the following areasTo install the PIR Motion Sensor, please follow these steps Door/Window DetectorChange the Battery Door/Window Detector for DC 12V batteryLCD display on the Main Console for Door/Window Detector Installing the Door/Window DetectorInstalling for DC 12V Detector TamperMini Siren Summary of Program Main Console Summary of Sensors and Zone Settings DescriptionsSpecifications Learning Place Zone LabelItems Installation TemplateSpecifications Page It’s all on the web
Top Page Image Contents