LOREX Technology WA-410 instruction manual

Page 28

“Installation template for wall mounting of main control panel”

1.Use the template on the right to mark positions for mounting screws to install the main control panel on the wall.

2.Once the mounting screw positions have been marked, drill 3/16” pilot holes and install the plastic wall anchors supplied.

3.Install the mounting screws into the plastic wall anchors so that the heed of the screw extends approximately 1/4” from the wall.

4.Remove the rubber/plugs located at the top 2 holes on the bottom of the main control panel, and line up these holes with the mounting screw heads. Slide the main control panel over the mounting screws and gently push down onto the screws so that it is secure.

27

Image 28

Contents Wireless Home Security System Table of Contents Important Safety Instructions Expandability IntroductionPersonalized Planning for Installation Setting Alarm ZonesPowering the Main Console Choosing LocationConnecting the Telephone Line Setting the AntennaAbout Passwords Mounting the Main ConsoleOperation Main Console LCD Panel IllustrationAntenna Used for wireless reception DC Power Jack DC supply inputSpeaker Line JackSystem Option menu Press 0 to start setting Setting Message Rec Sel Msg 1 25 Sec Setting Message Play Sel Msg 1 25 SecSetting Dialer Mode Setting Change Code InstallSequence Programming Menu Replacement Menu Clear MenuFunction for Master Menu Factory Default Password Check Function Speed Dial FunctionArm or Disarm Via the Telephone Line for Tone Mode Auto-dialer priorityResponse message as listed below If system is triggeredHour Mode Gas Detector and Remote Control Handset Panic buttonLCD MSG Message indicating on LCD Away and H-HOME modesRemote Control Handset Zone Address SettingTo Arm or Disarm with the Remote Control Handset Remote Sensor Armed HomePIR Motion Detector Main FeaturesPanic Replace the Battery Installing the PIR Motion SensorLow battery Do not install any PIR motion sensor in the following areasTo install the PIR Motion Sensor, please follow these steps Door/Window DetectorChange the Battery Door/Window Detector for DC 12V batteryInstalling the Door/Window Detector Installing for DC 12V DetectorLCD display on the Main Console for Door/Window Detector TamperMini Siren Summary of Program Main Console Summary of Sensors and Zone Settings DescriptionsSpecifications Learning Place Zone LabelSpecifications Installation TemplateItems Page It’s all on the web