LOREX Technology WA-410 Remote Control Handset, Zone Address Setting, Remote Sensor Armed Home

Page 17

Remote Control Handset

The key chain Remote Control Handset is a convenient way to arm (Home / Away mode) or disarm this system. Before using this device, please program it into the main console via the sequence programming menu.

DC12V

LEGEND

1.TRANSMIT LED

2.DISARM KEY

3.AWAY KEY

4.HOME KEY

5.PANIC KEY

6.BATTERY

1.TRANSMIT LED : The LED will light when the device is transmitting

2.DISARM : Press this button to disarm the system or clear the message

3.AWAY : Press this button to set the system in the AWAY Arm mode

4.HOME : Press this button to set the system in the HOME Arm mode

5.PANIC : Press this button to trigger the alarm and activate auto-dialer

6.BATTERY COMPARTMENT : For 12V alkaline battery

Zone Address Setting

Enter the Installer code and press ‘1’to activate the “Sequencing Programming Menu”. Press the PANIC button for 1 sec, the red LED will also light for 1 sec. The main console will emit a long ‘Beep’, and the LCD panel will show ‘Sensor Added’. The sensor has been set successfully.

To Arm or Disarm with the Remote Control Handset

•Press the “AWAY” button to arm the system in the AWAY mode.

63 REMOTE SENSOR

Armed AWAY

•Press the “HOME” button to arm the system in the HOME mode.

63REMOTE SENSOR Armed HOME

16

Image 17

Contents Wireless Home Security System Table of Contents Important Safety Instructions Personalized IntroductionExpandability Setting Alarm Zones Planning for InstallationPowering the Main Console Choosing LocationSetting the Antenna Connecting the Telephone LineAbout Passwords Mounting the Main ConsoleLCD Panel Illustration Operation Main ConsoleDC Power Jack DC supply input Antenna Used for wireless receptionSpeaker Line JackSystem Option menu Press 0 to start setting Setting Message Play Sel Msg 1 25 Sec Setting Message Rec Sel Msg 1 25 SecSetting Dialer Mode Setting Change Code InstallSequence Programming Menu Clear Menu Replacement MenuFunction for Master Menu Factory Default Password Speed Dial Function Check FunctionAuto-dialer priority Arm or Disarm Via the Telephone Line for Tone ModeResponse message as listed below If system is triggeredGas Detector and Remote Control Handset Panic button Hour ModeLCD MSG Message indicating on LCD Away and H-HOME modesZone Address Setting Remote Control HandsetTo Arm or Disarm with the Remote Control Handset Remote Sensor Armed HomePanic Main FeaturesPIR Motion Detector Installing the PIR Motion Sensor Replace the BatteryLow battery Do not install any PIR motion sensor in the following areasDoor/Window Detector To install the PIR Motion Sensor, please follow these stepsDoor/Window Detector for DC 12V battery Change the BatteryInstalling for DC 12V Detector Installing the Door/Window DetectorLCD display on the Main Console for Door/Window Detector TamperMini Siren Summary of Program Main Console Descriptions Summary of Sensors and Zone SettingsLearning Place Zone Label SpecificationsItems Installation TemplateSpecifications Page It’s all on the web