LOREX Technology WA-410 Change the Battery, Door/Window Detector for DC 12V battery

Page 21

Door/Window Detector (for DC 12V battery)

Button function

1. Magnet.

2. Transmit LED : When the sensor is activated, the LED will light for 1 sec.

3. Magnet sensor

4. Battery Cover : Remove the

cover and install one 12V alkaline battery here.

Note: The magnet and magnet sensor must be placed in parallel position (triangle arrow) to ensure a better setting.

Change the Battery

When the sensor sends a low battery message to the main console, remove the old battery and replace it with a fresh alkaline battery. The low battery message on the LCD is shown below

63 WINDOW SENSOR

01 Low battery

Zone address setting

You can set the sensor as “ Door “ or “ Window “ detector by using the jumper selector. If you want to set the sensor as a Door sensor, put the Jumper on the “D” side. (If the set Jumper is on the “W” side, the sensor becomes a Window sensor).

DOOR / WINDOW SELECT

DOOR / WINDOW SELECT

TYPE S

TYPE SEL

JUMPER

DOOR

WINDOW

DC 12V

JUMPE

DC 9V	W

Notes on the Door/Window Detector

20

Image 21

Contents Wireless Home Security System Table of Contents Important Safety Instructions Introduction ExpandabilityPersonalized Setting Alarm Zones Planning for InstallationPowering the Main Console Choosing LocationSetting the Antenna Connecting the Telephone LineAbout Passwords Mounting the Main ConsoleLCD Panel Illustration Operation Main ConsoleDC Power Jack DC supply input Antenna Used for wireless receptionSpeaker Line JackSystem Option menu Press 0 to start setting Setting Message Play Sel Msg 1 25 Sec Setting Message Rec Sel Msg 1 25 SecSetting Dialer Mode Setting Change Code InstallSequence Programming Menu Clear Menu Replacement MenuFunction for Master Menu Factory Default Password Speed Dial Function Check FunctionAuto-dialer priority Arm or Disarm Via the Telephone Line for Tone ModeResponse message as listed below If system is triggeredGas Detector and Remote Control Handset Panic button Hour ModeLCD MSG Message indicating on LCD Away and H-HOME modesZone Address Setting Remote Control HandsetTo Arm or Disarm with the Remote Control Handset Remote Sensor Armed HomeMain Features PIR Motion DetectorPanic Installing the PIR Motion Sensor Replace the BatteryLow battery Do not install any PIR motion sensor in the following areasDoor/Window Detector To install the PIR Motion Sensor, please follow these stepsDoor/Window Detector for DC 12V battery Change the BatteryInstalling for DC 12V Detector Installing the Door/Window DetectorLCD display on the Main Console for Door/Window Detector TamperMini Siren Summary of Program Main Console Descriptions Summary of Sensors and Zone SettingsLearning Place Zone Label SpecificationsInstallation Template SpecificationsItems Page It’s all on the web