Samsung SCC-B9372P manual Function & installation, DC Level Volume Screw Cap

function & installation

	VIDEO
	6
1	2
	POWER

45

3

[THE OTHER SIDE VIEW]

FUNCTION

1Protective Film over Front Glass : Remove this film before operating the Camera.

2Focus/Zoom Lever Bolt Screws: Used to fix the Focus/Zoom ring to the lens internally. Be careful not to lose this small bolt screws which need not be touched other than by a service technician.

3Focus/Zoom Ring Fixing Screws: Used to fix the Focus/Zoom Ring at the desired position after adjusting the lens angle and focus setting as described below.

4Focus and Zoom Ring: These two rings are used to accurately adjust the viewing angle and to sharply focus all objects within the lens field of view.

-Loosen the fixing screws ( 3 ) to turn the Zoom and Focus ring.

i)To widen the viewing angle turn the “Zoom Ring” to “W” (Wide).

ii)To obtain a closer view turn this ring to “T” (Tele).

-After adjustment of the viewing angle then adjust the “Focus Ring” between “N” (Near) or “” (Far) until the sharpest focus is achieved.

- Then tighten the fixing screws ( 3 ) on each ring.

-After tightening you should check that angle and focus is still accurate.

5 DC Level Volume Screw Cap :

-Loosen the DC level volume screw cap on the camera body.

i)For a brighter screen turn the DC level volume slowly toward “H” (counter-clockwise),

ii)For a darker screen turn it toward “L” (clockwise) with a driver.

6Bracket : Used to install the camera to the desired location.

ENG

function & installation _03