Therma-Tru Fiber-Classic, Smooth-Star manual Install Stationary Panel, Install Anchor Blocks

Page 11

14 INSTALL STATIONARY PANEL

From exterior side of system, install stationary panel by inserting top of panel up into exterior channel in head jamb.

Rotate12bottom of panel in until inactive door riser leg sets into groove.

Slide panel tightly against side jamb

Wipe off excess caulking.

As reference, the exterior side of the panel is always the pre-finished side.

Exterior channel

Head Jamb

Exterior

Sill

15

INSTALL ANCHOR BLOCKS

Head

Insert anchor blocks into top and bottom of inactive door panel.

Using a 1/8" drill bit, drill through angled “toe-screw” hole into head and sill.

Install #10 x 2 ½" pan head screws into “toe-screw” hole.

Fasten anchor block to panel with #10 x 1 ½" pan head screws.

Anchor block

#10 x 2 ½" pan head screw

#10 x 1 ½" pan head screw

“toe-screw” hole

Sill

10

Image 11

Contents Double Unit Assembly & Installation Screen sold separately Active Panel Inactive Panel Screw Chart LAY Frame Components Onto Work Area If APPLICABLE, Install TOP-HUNG Screen TrackInstall Sill CAP Base Attach Head to Jambs Attach Sill to JambsApply Corner Pads to Sealing FIN Drip CAP InstallationFrame Installation SET Unit Into Rough Opening Apply Silicone Sealant to Sill and FinsPlumb Side Jambs Level SillApply Sealant to Inactive Door Riser Secure Frame in Rough OpeningInstall Anchor Blocks Install Stationary PanelAdjust Rollers Install Active PanelAttach Inactive Interlock Install Active InterlockAttach Strike Plate Handle InstallationInsert Panel Bumper Attach Foot Bolt Install Sill CAP TOPPrep Door for Foot Bolt Sliding Screen Door Install Foot Bolt KeeperInsert Plugs Attach Jamb CoverActive panel edge Dia holes 1 deep Towards Page Finishing Instructions Jamb Extension Information WEATHERPROOF, Finish and MaintainInterior Casing Attachment Sizing Information Door Handing Guide Patiodoorsystems