Therma-Tru Smooth-Star manual Apply Silicone Sealant to Sill and Fins, SET Unit Into Rough Opening

Page 8

APPLY SILICONE SEALANT TO SILL AND FINS

Run continuous beads of sealant across entire length of sill bottom and around entire perimeter of backside of sealing fin to provide a weather-tight seal.

Sealant

NOTE:

CONTINUOUS BEADS OF

SEALANT ARE REQUIRED.

SET UNIT INTO ROUGH OPENING

Exterior

From outside of house, set system into rough opening. Apply pressure on sill to set sealant.

Image 8

Contents Double Unit Assembly & Installation Screen sold separately Active Panel Inactive Panel Screw Chart LAY Frame Components Onto Work Area If APPLICABLE, Install TOP-HUNG Screen TrackInstall Sill CAP Base Attach Sill to Jambs Attach Head to JambsDrip CAP Installation Apply Corner Pads to Sealing FINFrame Installation Apply Silicone Sealant to Sill and Fins SET Unit Into Rough OpeningLevel Sill Plumb Side JambsSecure Frame in Rough Opening Apply Sealant to Inactive Door RiserInstall Stationary Panel Install Anchor BlocksInstall Active Panel Adjust RollersInstall Active Interlock Attach Inactive InterlockAttach Strike Plate Handle InstallationInsert Panel Bumper Attach Foot Bolt Install Sill CAP TOPPrep Door for Foot Bolt Install Foot Bolt Keeper Insert PlugsAttach Jamb Cover Sliding Screen DoorActive panel edge Dia holes 1 deep Towards Page Finishing Instructions WEATHERPROOF, Finish and Maintain Jamb Extension InformationInterior Casing Attachment Sizing Information Door Handing Guide Patiodoorsystems