Samsung AR30HPFUAWKNMG manual Cleaning the indoor unit, Cleaning the outdoor unit heat exchanger

Page 17

CleanAA ing the air conditioner

Make sure the power is turned off and unplugged from

the wall socket when cleaning the air conditioner.

Cleaning the indoor unit

Wipe the surface of the unit with a slightly wet or dry cloth when needed.

• Contact the service center when you clean the indoor unit

heat exchanger because it needs to be disassembled.

• Do not clean the display using alkaline detergent.

• Do not use sulfuric acid, hydrochloric acid, organic solvents (such as thinner, kerosene and acetone etc.) to clean the surface of the product or put any stickers on it. They may damage the surface of the air conditioner.

Cleaning the outdoor unit heat exchanger

When dust accumulates on the heat exchanger, it may decrease cooling performance. Therefore, clean it regularly.

Spray water to clean the dust.

• If it is difficult to clean the outdoor unit heat exchanger on

your own, contact service center.

Be careful with the sharp edges on the outdoor unit heat exchanger.

ENGLISH

Heat exchanger

(Illustration may differ slightly depending on the models)

Opening the panel

Tightly grab top of the front panel and pull it down to open.

Then slightly lift the panel up.

Air filter

17

SSEC_UMG_IB&IM_DB68-04508A_EN.indd 17

2014-2-10 14:56:53

Image 17
Contents English Contents Important safety symbols and precautions SafetAA y precautionsFollow directions Wall socketFor Using For Cleaning Operation ranges ChecAA king before useDisplay ChecAA king the name of the partsMain parts Remote controller buttons ChecAA king the remote controllerBattery changing time Remote controller displayStoring the remote controller Inserting the batteriesBasicAA function Press the button to set the desired fan speed Press the button to adjust the temperaturePress the Air swing button on the remote controller Using the Turbo functionAdjusA ting the air flow direction Vertical air flowPress the button on the remote controller AA modePress the Time Up or Time Down button to set the time Press the Set button to active it onPress the On Timer/Off Timer button SettinAA g the On/Off timerAdditional options available in On timer mode You can select from Auto/Cool/Dry/Fan/Heat ARHPmodelFrom the moment you have set the timer Using the Smart Saver functionIf the air conditioner is on If the air conditioner is off Turn off automaticallyWhen the air conditioner is turned on UsingAA the Auto Clean functionUsing the Quiet function Cleaning the outdoor unit heat exchanger Cleaning the indoor unitOpening the panel Heat exchangerCleaning the air filter CleanAA ing the air conditionerRemoving the Air filter Open the panel and put the Air filter outPeriodical checks MaintAA aining the air conditionerTroubAA leshooting Connection Flow movement changes. It is normalGeneral information Safety precautionsInstalling the unit Choosing the installation locationPower supply line, fuse or circuit breaker  a place where the air filter can be replaced easilyOutdoor Unit ChooAA sing the installation locationWhere sulfide gas exists When the air outlet is towards the wall When installing more than 1 outdoor unit Figure Description Top view Side viewAccessories in the outdoor unit case AccessoriesAccessories in the indoor unit case Optional accessories Fixing the installation plateTools required for installation General Tools Tools for test operationsConnecting the cable Connecting the assembly cableCable specification Installation Extend the assembly cable if necessaryEach wire is labeled with the corresponding terminal number Cut off the remaining foam insulation Smooth the cut edgesCutting or extending the pipe AAPurging the indoor unitUnscrew the caps at the end of each pipe Put a flare nut slightly into the pipe and modify the flareOuter Diameter CuttingAA or extending the pipeTwo hoses are firmly connected, there is no water leakage Drain hose installationHose tight Check for leakage on both side of the drain outletARHPseries Purging the connected pipesAdd refrigerant charge according to table below Adding Refrigerant30g of refrigerant R-22 must be added for each extra meter If you use a pipe shorter than 4 mFixing the indoor unit in place PerfoAA rming the gas leak testsAppropriate support wall or ground Outdoor unit installed on the wall by rackFixing the outdoor unit in place Press the Power button to stop the operation Press the Power button and check the followingFinalAA Check and Trial Operation Check the followingsInsulation tape to finish Apply heat to the contraction tube to contract itAfter tube contraction work is completed, wrap it with AR30HCFUAWK/MG AR36HCFUAWK/MG TechnAA ical SpecificationsEnglish Egypt Questions or COMMENTS?Air Conditioner
Related manuals
Manual 43 pages 5.33 Kb