Heatiator GB4336 Maintaining and Servicing the Appliance, Risk of injury or property damage

Page 37
15 Maintaining and Servicing the Appliance

15 Maintaining and Servicing the Appliance

Although the frequency of appliance servicing and maintenance will depend on use and the type of installation, a qualifi ed service technician should perform an appliance check-up at the beginning of each heating season.

Risk of injury or property damage WARNING

Risk of injury or property damage

Before servicing:

Turn off gas.

Turn off electricity to appliance.

Disable remote control, if one is present.

Ensure appliance is completely cooled.

After Servicing:

Replace any screen or barrier that was removed.

Reseal and reinstall any venting removed for servicing.

Before servicing: WARNING

Annual inspection by qualified technician recommended.

Check:

Condition of doors, surrounds and fronts.

Condition of glass, glass assembly and glass seal.

Obstructions of combustion and ventilation air.

Condition of logs.

Condition of fi rebox.

Burner ignition and operation.

Burner air shutter adjustment.

Gas connections and fi ttings.

Obstructions of termination cap.

Clean:

Glass.

Air passageways, grilles, control compartment.

Burner, burner ports.

Risk of:

Fire

Delayed ignition or explosion

Exposure to combustion fumes

Odors

CAUTION

Handle glass assembly with care.

Note: Clean glass after initial 3-4 hours operation. Longer operation without cleaning glass may cause a permanent white film on glass.

When cleaning glass door:

Avoid striking, scratching or slamming doors.

Do NOT use abrasive cleaners.

Use a hard water deposit glass cleaner on white fi lm.

Do NOT clean glass when it is hot.

Turn off appliance after 3-4 hours of operation and ALLOW TO COOL.

Remove and clean glass assembly.

Replace glass assembly and operate appliance for an additional 12 hours.

Refer to maintenance instructions.

After Servicing: WARNING

Fire Risk

Explosion Risk

Inspect external vent cap regularly.

Ensure no debris blocks cap.

Combustible materials blocking cap may ignite.

Restricted air flow affects burner operation.

Heatilator • GB4336/GB4992 • 4003-085 Rev H • 04/06

37

Image 37
Contents Models GB4336, GB4336L GB4336I, GB4336IL What to do if you smell gasGB4942, GB4942L GB4942I, GB4942IL B-VentGas ApplianceListing Label Information/Location Homeowner Reference InformationCongratulations Gas Type5 Vent Information and Diagrams Table of Contents8 Installing Vent Pipe 12 Appliance Setup1Listing and Code Approvals D. High Altitude InstallationsA. Appliance Certification C. BTU Specifications2Getting Started A. Design and Installation ConsiderationsNegative Pressure B. Negative PressureAsphyxiation Risk D. Inspect the Appliance and Components C. Tools and Supplies NeededAny such action may cause a fire hazard A. Select Appliance Location 3Framing and ClearancesFire Risk Fire Risk B. Construct the Appliance ChaseFire Risk Odor Risk C. ClearancesTop of Appliance Drywall A 48 in 1219 mm B max D. Mantel ProjectionsMantel Leg or Perpendicular Wall A1 in. 25mm min to perpendicular wallA. Vent Termination Minimum Clearances 4Termination LocationsFire Risk Explosion Risk A. Vent Guidelines 5Vent Information and DiagramsB. Vent System Configuration Fire Risk Asphyxiation RiskFire Risk Explosion Risk Vent supportsA. Pipe Clearances to Combustibles 6Vent Clearances and FramingB. Wall Penetration Framing C. Vertical Penetration FramingAppliance Preparation A. Installing Outside Air Kit Damper AssemblyRisk of Smoke Spillage Fire Risk Asphyxiation RiskC. Securing and Leveling Appliance B. Gas and Electrical ConnectionsNailing Tabs both sidesB. Attach Vent to Firebox Assembly 8Installing Vent PipeA. Assemble Vent Sections C. Securing Vent SectionsA. Fuel Conversion 9Gas InformationC. Gas Connection B. Gas PressureFire Risk Explosion Risk D. High Altitude InstallationsGas build-upduring line purge may ignite Fire Risk Explosion Risk Asphyxiation RiskB. Connecting to the Appliance A. Recommendation for WireC. Intellifire Ignition System Wiring 10 Electrical InformationOptional Accessories Requirements D. Standing Pilot Ignition System WiringOptional Junction Box Wiring E. Junction Box Installation A. Mantel Projections 11 FinishingB. Facing Material Fire RiskB. Clean the Appliance 12 Appliance SetupC. Accessories D.Install the RefractoryF. Log Removal/Replacement G. Glass Doors I. Air Shutter SettingH. Hood Fire Risk Combustion Fumes RiskA. Before Lighting Appliance 13 Operating InstructionsFire Risk Burn Risk HOT! DO NOT TOUCH SEVERE BURNS MAY RESULTB. Check Appliance Draft C. High Limit Safety SwitchNote to Qualified Service Technician WithoutWARNING RISK OF FIRE D. Lighting the ApplianceFOR YOUR SAFETY READ BEFORE LIGHTING LIGHTING INSTRUCTIONSNATURAL GAS FOR YOUR SAFETY READ BEFORE LIGHTINGLIGHTING INSTRUCTIONS TO TURN OFF GAS TO APPLIANCEE. After the Appliance is Lit F. Frequently Asked QuestionsInitial Break-inProcedure IssueA. Standing Pilot Ignition System 14 TroubleshootingSymptom Possible CausesPossible Causes SymptomCorrective Actions Frequent pilot outageSymptom B. Intellifire Ignition SystemPossible Causes Corrective ActionsPossible Causes SymptomCorrective Actions Pilot sparks, but pilot willClean 15 Maintaining and Servicing the ApplianceWhen cleaning glass door Risk of injury or property damageMaintenance Tasks Maintenance and Service TasksInspect one is not present16 Reference Materials A. Appliance Dimension DiagramFigure 16.1 Appliance Dimensions ModelB. Service Parts List Service PartsGB4336 SERIES Exploded Parts DiagramGB4336 SERIES Service PartsDescription of Part GB4336Intermittent Pilot Valve Assembly Standing Pilot Valve AssemblyService Parts Service Parts ListGB4336 SERIES Service PartsDescription of Part GB4336Service Parts GB4942 SERIESExploded Parts Diagram Beginning Manufacturing Date 1/19/04GB4942 SERIES Service Parts# Description of Part GB4942Standing Pilot Valve Assembly Service PartsIntermittent Pilot Valve Assembly Service Parts ListGB4942 SERIES Service Parts# Description of Part GB4942ID4 Insulated Duct C. Optional Componentsin. 102 mm UD4 Uninsulated Duct 4 in. 102 mm 42 in 1067 mmThis page intentionally left blank This page intentionally left blank Gas Appliance Fireplace Limited Lifetime Warranty D. Limited Lifetime WarrantyLimited Lifetime Warranty 1 Year Limited WarrantyHearth & Home Technologies Inc E. Contact Information1915 W. Saunders Street Mt. Pleasant, Iowa DO NOT DISCARD THIS MANUAL