18
INSTALLATION
Installing Logs (Cont.)
INSTALLATION
Continued
Single Burner Seasonal Oak Models
WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
The Seasonal Oak Log Set is a reversible log set. This means that the two bottom logs may be turned to face either direction. The top log, however, must remain in the same position. Do not modify logs. Only use logs supplied with heater.
1.Place the back log onto the back of the base assembly. Make sure log sits forward against the two posts in front of log (see Figure 36). This log may be turned to face either direction.
2.Place front log onto grate on front of base assembly. The log will fit down between grate fingers and posts on front of base assembly (see Figure 37). This log may be turned to face ei- ther direction.
3.Place the crossover log on top of the back log and front log making sure pins are inserted into holes on top of logs 1 and 2 (see Figure 38). This log must be placed as shown in Figure 38 or the pins will not seat into holes.
4.Add lava rock around base of heater if desired. Do not put lava rock on logs or burner.
Back Log
Post
Base
Assembly
Post
Post
Grate
Fingers
Figure 37 - Installing Front Log
Crossover Log
Hole in
Front Log
Front Log
Base
Assembly
Post
Hole in Back Log
Figure 38 - Installing Crossover Log
Figure 36 - Installing Back Log
For
.
.com
