R
Castile Pellet Stove
B.Leg Leveling System
1.Thread Allen bolts through nuts until flush. Figure 18.1. The Allen bolts and nuts are included in the component pack inside the stove firebox.
2.Slide assembled nuts and bolts into slots on legs with the nuts on the bottom. Figure 18.2. Use a 5/32 in. (3.96mm) Allen wrench to adjust legs up and down to desired level. Figure 18.3
Offset Collar |
|
3 to 6 inch | Rear Exhaust Outlet |
| |
Top Vent Adapter |
|
3 to 3 inch |
|
Use hole on each side | |
| as drilling guide |
Figure 18.4 |
|
Figure 18.1 | Figure 18.2 |
Figure 18.3 - Bolt fully extended
C. Top Vent Adapter Installation
3 to 3 inch Top Vent Adapter
3 to 6 inch Top Vent Offset Adapter
Installing the Top Vent Adapter
1.Put a layer of high temperature silicone on the 3 inch (76mm) rearexhaust outlet. Figure 18.4
2.Slide the top vent adapter onto the rear exhaust outlet and adjust the assembly to a vertical position. Figure 18.4
3.Drill 4 holes with #26 drill bit (provided) into the back of the appliance using the outer shield as a pattern (make sure the assembly is vertical). Figure 18.4
4.Install the 4 mounting screws.
Mount with |
4 screws |
Figure 18.5
D.Rear Vent and Rear Vent to Top Vent Adapter Installation
Rear Vent | Rear to Top Vent |
| |
| |
Figure 18.6 | Figure 18.7 |
5.Drill 2 holes with #26 drill bit through the rear exhaust outlet using the 2 holes already in the short horizontal pipe in the top vent adapter as a guide. Install the 4 screws. Figure 18.5.
6.Install the vent pipe into the top vent adapter (be sure to silicone all joints).
1.Put a layer of high temperature silicone on the 3 inch (76mm) exhaust outlet. Figure 18.4
2.Slide the adapter onto the rear exhaust outlet and adjust the assembly to the appropriate position.
3.Install the vent pipe into the adapter (be sure to silicone all joints)
Page 18 | October 11, 2005 |